Laserfiche WebLink
In sta I I ati oe-*,�.G u i d e: AdvanTexIm-AX-reatment Systems <br /> Installing Filtrate Return Line and Discharge Line <br /> Step 6A: Determining Elevations and Connections <br /> Install the 2" PVC Filtrate Return Line from the outlet - <br /> coupling in the bottom of the AdvanTex Filter to the Minimum 1.5" <br /> inlet side of the Split-Flow Tee. This 2" Filtrate Return <br /> Line should be sloped a minimum of 114" per foot. If the g , <br /> Filtrate Return Line is LESS than 6' long, provide a mini- <br /> mum of 1.5" total elevation difference from the outlet of - <br /> the filter to the inlet of the Slit- - <br /> Flow Tee.e. Be sure the 2 <br /> Filtrate Return Line is continuously sloped. Do not allow Determining elevations of filtrate return line <br /> any undulations or flat sections as this will impair proper <br /> drainage and air movement. <br /> Out <br /> Be sure the Split-Flow Tee is installed in the proper orien- Out <br /> tation. The Filtrate Return Line connects to the end of the �� <br /> Split-Flow Tee labeled "IN."The discharge pipe connects . <br /> to the. end of the Split-Flow Tee labeled "OUT." <br /> Step 613: InstaIling Split-FIow Tee Cut-away of split-flow tee <br /> When gluing the Split-Flow Tee, orient it to accommodate <br /> the slope requirements of the discharge line, as shown in " <br /> 'Minimum 114"ht <br /> the photo at right. The discharge line should have a mini- x x <br /> mum slope of 114" per foot and a maximum slope of 2 " =Maximum 27/W,,,� .� <br /> inches per foot (10 degrees). If a slope of greater than 10 ' - <br /> k degrees is necessary, install the first 12 inches of the line at - <br /> less than 10 degrees; then use fittings to achieve the neces- <br /> sary slope greater than 10 degrees. Split-flow tee orientation and discharge line <br /> slope requirements <br /> k <br /> Ste <br /> f Installing Passive Air Vent <br /> + Step 7A:Attaching Air Vent cT Mfr j;h <br /> Using 2" PVC pipe, plumb the passive air vent to the 2" <br /> fitting that protrudes through the filter wall (opposite end <br /> •��z <br /> from outlet fitting). Be sure the vent line is sloped to drain y <br /> into the textile filter, to prevent accumulation of water in <br /> the vent line. k. <br /> Left Air intake attached to filter <br /> EIM•ATX-AX-1 ©2001 Orenco Systems' Inc. <br /> Rev 1.48/61 Information subject to change without notice <br />