Laserfiche WebLink
Installation Guy e: AdvanTexr"-AX Treats, nt Systems i <br /> t + tions, the recommended surge volume is approximately 150 <br /> to 250 gallons. The surge volume is the volume between <br /> the low liquid level and the high water alarm float. <br /> After the Stinger Pipe is cut to the correct length, install <br /> into the RSV Body and tighten the set screws. Determine <br /> handle length. Install handle in the top of the RSV Body <br /> and secure with set screw. <br /> For Mode 3 installations, the duckbill model RSV is <br /> required, which has a flexible PVC tube that vents the RSV <br /> Cage to atmosphere. Push the flexible PVC tube onto the <br /> insert fitting on the Cage. Thread the other end of the tube <br /> through the Tube Holder at the top of the RSV Body. Leave <br /> _. about b" of tube extending through the Tube Holder. Any <br /> i Tube excess can be cut off. There is no vent tube required for <br /> { Holder <br /> i: Mode I installations. <br /> r r Step 51: Sliding RSV into Bracket <br /> Carefully lower the RSV into the bracket attached to the <br /> inside of the access riser. Slide the RSV down until the <br /> two locating stops come in contact with the top edge of <br /> - the bracket. <br /> Sliding RSV into bracket <br /> �I <br /> I <br /> r <br /> N <br /> I <br /> O 2001 Orenco Systems Inc. EIM-ATX-AX-1 <br /> rniormntion subject to change without notice Rev 1.48/01 <br />