Laserfiche WebLink
r� <br /> Replacing the mini-boot <br /> NOTE:There are two mini-boot and spout assemblies. These assemblies are not interchangeable! <br /> Please use the following table to install the correct mini-boot. <br /> •00 Mini-Boot Assembly Spout <br /> 6395B 8155 <br /> 405219906 405220901 <br /> Replacing the mini-boot for nozzles with EOR spouts <br /> The Mini-Boot Assembly for nozzles with the Enhanced ORVR Recognition (EOR) spout has part <br /> number 405219906. As shown below, the EOR spout has an elongated lower anchor, and the <br /> mini-boot has an "E" on the push plate inside the boot. <br /> Removing the mini-boot <br /> 1. To remove the old mini-boot, unscrew and remove the mini-boot clamp. (See image <br /> reference 2 in "Illustration and replaceable parts") <br /> 2. Grip the mini-boot and rotate back and forth a maximum of 5 degrees in each direction <br /> while gently pulling to separate the mini-boot from the nozzle. <br /> Installing the new mini-boot <br /> NOTE: Heating the mini-boot in water softens the material, making it easier to install. <br /> 1. Use a push rod checking tool (.050 hex wrench or 1/16" drill bit) to verify that a clear hole <br /> condition exists in the push rod hole of the spout body before proceeding. <br /> 2. Align the push rod extending from the nozzle end of the boot with the 1/16" hole in the <br /> spout body, and align the 3/16" hole in the mini-boot with the 3/16" pin on the spout body. <br /> r <br /> C � <br /> 4 T f+ CARB approved IOM 2-HEAL Y"900 Nozzle Series-Execu ive Orders VR-201 and VR-202 <br />