Laserfiche WebLink
3. Start the push rod into the 1/16" hole and slide the boot axially into engagement with the <br /> spout body and the boot location pin while limiting angular rotation of the boot to <br /> 5 degrees in each direction to avoid bending the push rod. <br /> 4. Install the mini-boot clamp and tighten securely. Verify that the HEALY " logo on the <br /> mini-boot is aligned with the top center of the nozzle. <br /> 5. Verify that the nozzle will not dispense fuel when the dispenser is authorized (ready <br /> to dispense fuel) and the boot is in a free state by holding the nozzle into an approved <br /> container (do not compress the mini-boot in any manner) and actuate the nozzle. No <br /> fuel should dispense. If fuel does not dispense, proceed to the next step. Any nozzle that <br /> dispenses fuel with the mini-boot in a free state condition must be repaired or replaced. <br /> 6. Verify that the nozzle will dispense fuel when the dispenser is authorized and the nozzle <br /> spout is inserted into a vehicle fill-pipe to a position 1/8" short of locking the spout anchor <br /> ring over the rim of the fill-pipe opening or manually held back while dispensing into an <br /> approved container. Any nozzle that does not dispense fuel must be repaired or replaced. <br /> Replacing the spout <br /> NOTE:The following procedures require the Spout Assembly. <br /> 1. Use a Phillips screwdriver to remove the#8 pan head spout screw and 0-ring that hold the <br /> spout in place. (See image reference 14 in "Illustration and replaceable parts.") <br /> 2. With the screw removed, using a maximum twisting motion of 15 degrees in each direction, <br /> separate the nozzle body and the spout. Be sure that the three 0-rings from the discarded <br /> spout assembly do not remain in the nozzle body. There is a fourth 0-ring, furthest from the <br /> opening that remains inside the nozzle. Leave this 0-ring in place. <br /> Installing the new spout <br /> 1. Install the new, pre-lubed 0-rings (included with the Spout Assembly) on the new spout <br /> assembly. <br /> 2. Carefully insert the spout into the nozzle, lightly pushing together until the spout aligns <br /> itself and resistance is felt. Using a maximum twisting motion of 15 degrees and light <br /> pressure, slide the pieces together, seating the o-rings and aligning the screw threads in the <br /> spout housing with the hole in the nozzle casting. <br /> 3. Install the new#8 panhead spout screw and 0-Ring, and tighten securely to 12 inch/lbs. <br /> 4. Follow steps 5 and 6 in "Installing the new mini-boot" to test nozzle operation. <br /> 5 <br /> CARB approved IOM 2-HEAL r 900 Nozzle Series-Executive Orders VR-201 and VR-202 <br />