COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

[HIEFALY] Franklin Fueling Systems Healy Model 75 Series Low Perm Hose Assemblies Follow all federal, state, and local laws governing the installation of this product and the entire WarningA system. When no other regulations apply, follow NFPA 30, 30A, and 70 from the National Fire Protection Association. Failure to do so could result in severe injury, death, serious property damage and/or environmental contamination. Highly flammable vapors or liquids may be present in the environment in which this equipment is WarningA installed or serviced. Installing or working on this equipment means working in an environment that presents risks of severe injury or death if instructions and standard industry practices are not followed. Follow all applicable codes governing the installation and servicing of this product and the entire system. Always lock out and tag electrical circuit breakers while installing or servicing this equipment and Danger related equipment.A potentially lethal electrical shock hazard and the possibility of an explosion or fire from a spark can result if the electrical circuit breakers are accidentally turned on during installation or servicing. Do not smoke while working on or near this equipment, and use only non- sparking tools. Healy 75 Series Hoses and Hose Assemblies should be serviced by a Healy Certified Technician. However, GDF Owner/ Operator can remove and install hanging hardware (nozzle, curb hose, breakaway, flow limiter and whip hose). Hoses should be inspected for kinks, flat spots, abraded outer cover(wire strands visible)and leaking fittings on a weekly basis. Note: It is the responsibility of the installer to be familiar with the current requirements of state, federal, local codes and air district rules and regulations for installation of gasoline dispensing equipment. It is the responsibility of the installer to be aware of all the necessary safety precautions and site safety requirements to assure a safe and trouble free installation. The warranty sheet provided with the component is to remain with the component, and must be provided to the end-user. 1. Hose Length Select the correct whip hose and curb hose by selecting the correct thread type and hose length. The maximum length of the hose assembly shall not exceed eighteen (18)feet. Lengths greater than eighteen (18)feet are permitted if acceptable to authorities having jurisdiction. 2. Installation Instructions 2.1 Lubricate any O-rings or Quad Seals before installing the hose assembly into an adaptor, breakaway or nozzle assembly to make it easier to install and prevent the seal from getting cut. Motor oil (any weight) is acceptable for lubricating an O-ring or Quad Seal. 2.2 Connect hose assembly to nozzle, hose adaptor, breakaway, or flow limiter(if equipped). 2.3 Tighten hose connections between 35 to 70 foot pounds. 2 3 Rule of Thumb: 0-rings(item 3) to Nozzle and Hose Adaptor Quad Seals(item 2) to Breakaway(or Flow Limiter)