Laserfiche WebLink
VST Installation Procedure for ` Vapor Systems Technologies,Inc. <br /> r 650 Pleasant Valley Drive <br /> Phase II EVR Vacuum Assist 1 Springboro,Ohio 45066(USA) <br /> Low Permeation Fuel Hoses Toll Free: 1-888-878-4673 <br /> Part Number Series:V34EV Phone:937-704-9333 <br /> Fax:937-704-9443 <br /> www.vsthose.com <br /> each hose joint connection for liquid leaks and meter creep. Make <br /> proper adjustments at the hose connection if necessary. <br /> 7. Check the nozzle shut-off action by dispensing fuel into an approved <br /> container at least three times to assure proper automatic operation. <br /> To test, operate the nozzle and submerge the spout tip in fuel until <br /> the fuel level covers the vent hole. The main valve of the nozzle <br /> automatically shuts off when liquid covers the vent hole at the end <br /> of the spout. The dispenser should deliver a minimum of 3 gpm. <br /> Hold open latch will disengage automatically when liquid covers <br /> the vent hole in the spout. <br /> 8. Measure the resistance between the dispenser outlet casting and <br /> the tip of the nozzle spout. Use an electronic multimeter set on <br /> the high range of the ohmmeter function. Resistance should not <br /> indicate more than 70,000 ohms per foot of the hose. Example:The <br /> measured resistance of a 12 foot hose must not exceed 840,000 <br /> ohms(840 kilohms). <br /> MAINTENANCE <br /> Inspect hoses regularly for damage, loose connections, leaks, kinks, <br /> blisters, bulges, flattened areas, soft spots, or any cuts/gouges deep <br /> enough to expose the reinforcement beneath the hose cover. Replace <br /> as necessary. Subject to customer abuse, hoses should be replaced <br /> when damaged. <br /> The hose is designed and constructed to give lasting service if properly <br /> handled and maintained. If for any reason it should need attention, <br /> contact your VST distributor for proper disposition. <br /> NOTE <br /> Due to the abuse, misuse, changing gasoline formulas, variation in <br /> maintenance practices, environmental conditions, and /or conditions <br /> beyond the manufacturer's control, dispensing equipment may need <br /> replacement before five(5)years. Inspections and proper maintenance <br /> procedures should be followed by the station manager to determine if <br /> replacement is required before five(5)years. <br /> WARNING <br /> Unauthorized rebuilding or modifying of hoses voids ALL approvals and <br /> warranties.VST products must be used in compliance with applicable <br /> federal,state,and local laws and regulations. <br /> 4-2 <br /> CARB Approved 10M 4—EVR Vacuum Assist Fuel Hoses VR-201 and VR-202 09/16 <br />