Laserfiche WebLink
❑ The seven (7) wires from the sealed nipple assembly are connected as follows: <br /> Red (either one) connected to `OUTPUT Von output terminal board <br /> Red (other one) connected to `OUTPUT Z on output terminal board <br /> Purple connected to `FAULT' on output terminal board <br /> Orange connected to `FAULT COMMON' on output terminal board <br /> Green — connect the ring lug supplied and then attach to chassis, see photo O. <br /> Black — connect to Motor terminal on power input terminal strip <br /> White — connect to Neutral on input terminal strip <br /> ❑ The black wire on the power jumper is connected to `Power In' and the white wire is connected <br /> to 'Neutral' on the input terminal strip. The orange connector on the other end of the black and <br /> white pair is connected to any available power plug on the dispenser harness. The dispenser <br /> power harness is composed of a black, white and green wires running together along the <br /> center rail and has orange, 3-pin connectors that will mate with the power wire from the <br /> MC100-1 module, see photo P. <br /> Disconnect <br /> Output _ <br /> *, Power connector cabl <br /> s <br /> Signals in <br /> Power wires to module <br /> Power in <br /> F Black White&Green dispenser power harness <br /> Chassis connection <br /> Photo O Photo P <br /> 11. CONNECTING HEALY SYSTEMS DISPENSING EQUIPMENT <br /> ❑ Completing the connection of Healy Systems dispensing equipment requires the installation <br /> of Healy Systems Phase II dispenser adaptors, hoses and nozzles (Hanging Hardware). <br /> ❑ If applicable, remove existing non-Healy hanging hardware (from the dispenser product <br /> outlet adaptor, to and including the nozzles). <br /> - Vapor ready dispensers may require a Healy Systems adaptor to make the hose threads <br /> compatible with other Healy Systems equipment. Install necessary adaptor following <br /> instructions packed with the adaptor. Various adaptors and pigtails are available, <br /> depending on how the dispenser is configured: M34 metric (Healy designation F3 or S3) or <br /> balance ready (Healy designation S4). <br /> - Healy Vapor Recovery Hoses are available in various lengths to satisfy local ordinances <br /> and still provide "far side" fueling capability. Install these following instructions contained on <br /> the shipping box. <br /> 8-11 <br /> CARO Approved IOM 8-Gilharco Encore 300 E 500 Series-Executive Orders VR-201 and VR-202 <br />