Laserfiche WebLink
Photo K Photo L <br /> 10. WIRING INSIDE THE ELECTRONICS COMPARTMENT. (SEE PHOTOS H, M & N) <br /> ❑ Secure the prewired Interface Module to the inside, between the two cross rails in the <br /> electronics compartment using the 8-32 screw, nut and washer supplied, see photo H. <br /> ❑ The wiring kit contains one jumper assembly. To install the jumper assembly, connect the <br /> stripped wires, one to terminal 1 of the solenoid disconnect relay, see photo H, and the other to <br /> terminal 6 of the same terminal block. <br /> ❑ Identify the P1200 location on the valve converter board and remove the connector from the <br /> socket on the board. Insert this connector into the mating socket on the jumper assembly. <br /> Insert the matching plug on the cable into the J1200 location on the board, see photos M & N. <br /> �w r <br /> r a - <br /> .!r P1200 <br /> P1200 P1204 A&B <br /> Photo M (300) Photo N (500) <br /> ❑ Using the cable harness attached to the module, identify and segregate the "A" side and <br /> "B" side connectors. The valve board connections are arranged by product, so it is important <br /> to be sure the "A's" and "B's" are connected to the appropriate sockets on the board. Connect <br /> the `signal' inputs Al, 2, 3 and B1, 2, 3 male/female connectors on the cable to the appropriate <br /> locations on the valve converter board. Be sure to keep the "A's" and "B's" together as there <br /> are "A's" and "B's" on both sides of the valve converter board. Note only connect the module <br /> to active gasoline products — do not connect to diesel or other unused valve connection <br /> op ints• <br /> 8-10 <br /> CARR Approved IGM 8-Gilbarco Enure 300 B 5D0 Series-Executive Orders VR-201 and VR-202 <br />