Laserfiche WebLink
16. GILBARCO ENCORE NOZZLE HOOK ADJUSTMENT <br /> This document details how to adjust Gilbarco Encore dispensing unit nozzle hooks to accommodate <br /> various manufacturers' nozzles. <br /> Required tools: drill, 7/32" or# 22 drill bit, 1/4" square-tip driver, 7 mm metric hex nut driver or socket, <br /> 3/8" nut driver or socket. <br /> NOTE: AC or battery powered drills must not be used at the dispensing unit because of the danger of <br /> explosion or fire due to the presence of hazardous vapors. <br /> Step One: Preparation. <br /> 1. Notify site personnel of work to be performed. <br /> 2. Secure work area. <br /> 3. Isolate dispensing unit from point-of-sale or pump controller. <br /> 4. Close shear valves. <br /> 5. Remove nozzle(s) from nozzle boot(s) and place on ground. <br /> Step Two: Remove nozzle boot(s) from dispensing unit. <br /> 1. Loosen two nozzle boot mounting screws. (See figure 1) using 1/4" square tip <br /> driver. Note: Save nozzle boot mounting screws for use later. <br /> 2. Remove nozzle boot from door by pulling toward you. <br /> � E <br /> e � <br /> � e <br /> Figure 1 <br /> Step Three: Remove nozzle hook from nozzle boot. <br /> 1. Place nozzle boot face down on work surface covered with soft cloth to protect nozzle boot face. <br /> 2. See figure 1 to identify existing nozzle hook retaining screw and nut locations. Identifying marks <br /> are located under right hand row of indented hole locations. Standard nozzle hook locations are A <br /> & D. <br /> B-18 <br /> GARB Approved 10M 8-Gilbarco Encore 300 B 500 Series-Executive Orders VR-201 and VR-202 <br />