Laserfiche WebLink
3. Use 7mm nut driver or socket to remove two upper hex head screws. <br /> 4. Use 3/8" nut driver or socket to remove two nuts from lower carriage bolts. <br /> 5. Remove nozzle hook and carriage bolts from nozzle boot. Save hex head screws, carriage <br /> bolts and nuts for use later. <br /> Step Four: Determine Nozzle Hook Position <br /> 1. Determine new nozzle hook position using chart below as guide to select new hole positions. See <br /> Figure 1 to identify nozzle hook retaining screws and nuts locations. Identifying marks are located <br /> under right hand row of indented hole locations. <br /> Upper Hex Head Lower <br /> Nozzle Type Screw Location Carriage Bolt & Nut <br /> Location <br /> Standard Factory Location All Non- A D <br /> Vapor <br /> VaporVac - OPW, Husky, Emco <br /> A D <br /> Wheaton <br /> VaporVac - Catlow, Richards B E <br /> Healy System C F <br /> Balance - Husky Short A D <br /> Balance - Husky Long, Emco Unmarked. Use nozzle <br /> Wheaton Long E hook carriage bolt <br /> holes as drill guide. <br /> Bottom hole set ("G" on Unmarked. Used <br /> Balance - OPW Long nozzle hook carriage <br /> Figure 1) bolt holes as drill guide. <br /> Step Five: Drill New Holes. <br /> 1. Use 7/32" or# 22 drill bit to drill new holes as needed. <br /> 2. When locations "E" or "G" are used by the upper hex head screws, the lower carriage bolt and <br /> nut hole set are unmarked. Temporarily mount the nozzle hook with the upper hex head screws <br /> in location "E" or "G" (as determined by chart) then use the nozzle hook carriage bolt holes as a <br /> drilling guide for the unmarked hole set. <br /> 3. Once holes are drilled, remove nozzle hook and clean up debris around hole set. <br /> Step Six: Assemble nozzle hook to nozzle boot. <br /> 1. Reverse Step Three to assemble nozzle hook to nozzle boot. <br /> Step Seven: Test nozzle hook adjustment using new nozzle. <br /> 1. Hold nozzle boot upright and insert nozzle over nozzle hook and into boot. Wiggle boot to <br /> verify the nozzle does not slip out of position. <br /> Step Eight: Install nozzle boot(s) onto dispensing unit. <br /> 1. Reverse Step Two and install the adjusted nozzle boot onto the dispensing unit. <br /> Step Nine: Re-insert Nozzles into the boot. <br /> 8-19 <br /> CARO Approved IOM 8-Gilbarco Encore 300 E 500 Series-Executive Orders VR-201 and VR-202 <br />