Laserfiche WebLink
❑ To obtain the electrical neutral connection for the module and motor requires interrupting <br /> the white (neutral) wire going to the three wire (5-position) connector on the Micro board. <br /> The module is supplied prewired with two white wires, one going to neutral on the power <br /> input strip on the module and the other going to pin location 1 on the disconnect relay. <br /> There is also a small white jumper going from pin 6 of the disconnect relay to a neutral on <br /> the power input strip. <br /> ❑ Get the white wire going to the power input strip and strip 3/8" off the end. Locate the white <br /> wire going to the MICRO connector and cut the wire, leaving about 1-1/2" going to the <br /> MICRO connector and the wire going back through the hole under the chassis. From the <br /> wire going under the chassis, strip 3/8" and connect to the previously stripped white wire <br /> going to power neutral. Use a wire nut supplied to secure and insulate the connection. <br /> ❑ Get the white wire going to pin 1 on the disconnect relay and strip 3/8" off the end. At the <br /> MICRO board, strip 3/8" off the other white wire in the connector and join with the first white <br /> wire. Secure with a wire nut supplied. <br /> Photo U Photo V <br /> ❑ Mount the interface module as shown in photo S using the 8-32 x 5/8" screw, supplied in <br /> the electrical kit. There is an existing hole in the chassis that is the right size and in the <br /> right place for the thread cutting screw. <br /> ❑ Install the following labels supplied: <br /> • NOTICE label for current increase, install on the inside of the cabinet panel near the <br /> existing power consumption label, see photo W. <br /> • Large NOTICE label relating to the vapor recovery upgrade and how to reset the <br /> electronic module should be installed near the module, where it will be readily visible <br /> to a service technician on the inside of the cabinet near the nozzle spout housing, <br /> see photo X. <br /> • UL, retrofit kit identification number, install near the electronic module. <br /> 13 <br /> CARE Approved IN 8-Gilbarco Gasboy 9866 Series-Executive Orders VR-201 and VR-202 <br />