Laserfiche WebLink
❑ Loosely position the module on the electronic chassis, see photo S, dress the wires coming <br /> from the sealed nipple assembly over to the module leave at least six inches longer than <br /> necessary to reach the terminal boards on the module. Cut off excess and strip all wires <br /> 1/2". <br /> L A <br /> Photo S Photo T <br /> ❑ Connect the wires from the sealed nipple to the interface module as follows: NOTE: <br /> Make sure the module screws contact the wire not the insulation. <br /> ■ Black wire to `motor ` on module <br /> ■ White wire to `neutral' on module <br /> ■ Red wire (either) to `output Von module <br /> ■ Red wire (other) to `output 2' on module <br /> ■ Orange wire to `fault common' on module <br /> ■ Purple wire to `fault input' on module <br /> ■ Green wire needs a #8 ring tong lug (provided) installed and connected to any <br /> chassis ground (frame) <br /> ■ Some sealed nipples may have extra wires, cap these and bundle them neatly out <br /> of the way. <br /> ❑ The single black wire on the module is routed down through the center black grommet hole <br /> and to the far side of the upper deck. Locate the black/green/white wire set from the factory <br /> installed sealed nipple that go to the switch bracket assembly and are marked "MICRO <br /> POWER". Select the black wire in the connector and Scotch-locTM the black wire from the <br /> module to the black wire in the connector, see photo T. <br /> ❑ The input signal wire connections are made to the valves terminal board under the <br /> electronics chassis. Route the yellow and red twisted pair (2 sets) of wires from the module <br /> through the rectangular hole containing the motor wires under the chassis to the valves <br /> terminal strip. Attach one set (yellow and red twisted pair) to one valve, and the other <br /> set to the other valve. The yellow and red wires supplied, with the terminals attached are <br /> screwed, one on each, on top of the existing yellow wires and red wires on each of the <br /> valve terminal boards. Be sure to keep the red and yellow pairs together on the same <br /> valve. <br /> 12 <br /> CARB Approved IN 8-Gilbarco Gasboy 9860 Series-Executive Orders VR-201 and VR-262 <br />