COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

9. INSTALLING THE HEALY VP1000 SYSTEM: NOTICE: WHEN DRILLING HOLES, ASSURE THAT THERE ARE NO HAZARDOUS VAPORS PRESENT AND DO NOT ALLOW CHIPS TO FALL DOWN INTO THE HYDRAULICS AREA. ❑ In order to get the vapor tubing from the pump into the vapor plumbing area, it is necessary to drill or punch two 1-1/8" holes on the sheet metal column near the edge of the shelf, see photo E. Use a tape measure and mark the centerline of the holes to be 1-1/4" in from the front edge of the sheet metal column. Measure down from the top of the column 5-1/2" and mark on the 1-1/4" centerline, measure down an additional 6-3/4" and mark on the centerline. These marks are the centers of the holes for the vapor pipes going to the VP1000. DO NOT DRILL— verify positions in the next steps. ❑ Get the vapor pump and install a 1/2" NPT x 5/8" flare elbow fitting into the `IN' and `OUT' ports using tape, not pipe dope. Looking at the face of the pump, completely tighten both fittings so they are facing the right. ❑ Position the pump on top of the sheet metal shelf over the electrical junction box on top of the electronics cabinet, with the fittings pointing toward the hydraulics cabinet and overhanging the edge of the shelf about 1/4". ❑ Slide the pump to fit against the hydraulics cabinet and position so as to allow for matching the location of holes that need to be drilled through the sheet metal. ❑ Satisfied that the fittings and hole marks line up, remove the pump and drill the two, 1-1/8" holes, marked above. ❑ Position the pump assembly on top of the sheet metal shelf and slide over so that the ports are accessible from the hydraulics area. 10. CONNECTING VAPOR LINES: (See Photos F, G & H) ❑ Make connections below using pipe thread compound as required. ❑ Install a 1" x 1/2" NPT reducing bushing in the top vapor line manifold tee where the 1" down pipe was removed see photo G. ❑ Install a 1/2" NPT x 5/8" flair straight fitting into the above. 8-8 CARE Approved IOM 8-Wayne Harmony Series(Balance)-Executive Orders VR-281 and VR-202