COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

11. INSTALLING THE SEALED NIPPLE ASSEMBLY: (See Photos O & P) NOTICE: THE INTERFACE MODULE THAT IS SUPPLIED HAS A HARNESS ATTACHED AND A WIRING PLUG FOR THE AC CONNECTIONS. ALSO SUPPLIED IS THE SEALED NIPPLE ASSEMBLY (1346) THAT MUST BE USED BETWEEN THE DIVISION 1 AREA (THE ELECTRONICS COMPARTMENT)AND THE DIVISION 2 AREA(THE SPACE ABOVE AND OUTSIDE THE ELECTRONICS COMPARTMENT). rr -- - - - ----- - - LL . . Photo I Photo P ❑ Get the 1346 sealed nipple assembly and carefully remove the first nut and washer over the wires. Thread these wires from inside the electronics compartment, up through the hole inside the "J" box, (bottom right) where the Wayne VACTM potted nipple was removed. Carefully replace the washer and nut over the wires and secure the unit into the box. ❑ At the VP1000, get and install the 1/2" male x 3/4" female adaptor over the wires coming from the motor. Do not use pipe dope on these fittings and be sure there is at least five full threads of engagement of the fittings in their respective couplings. ❑ Thread the pump wires through the elbow that was removed from the Wayne VACTM motor electronics housing and screw the threaded end with the "0" ring into the 1/2" male x 3/4" female adaptor installed in the above step. Tighten so that the elbow faces away from the "J" box, see photo P. ❑ Get the electrical tube that was left hanging during the Wayne VACTM removal, and route up to the VP1000 VAC pump as shown in photo P. ❑ Run the electronic wires from the VP1000 through the electrical tube and into the "J" box as shown. Reconnect the electrical tube to the elbow on the VAC pump. ❑ In the "J" box, leave about 6" of wire on both the wires coming from the motor and from the sealed nipple, cut off excess wire and strip approximately 1/2" of insulation from all wires. B-11 CARE Approved IBM 8-Wayne Harmony Series(Assist)-Executive Orders VR-281 and VR-282