Laserfiche WebLink
Appendix AA <br /> 7150 Overfill Valve Upper Tube Calculation Worksheet <br /> Important: This is meant to be supplemental worksheet and not a substitute to following the installation <br /> manual instructions. All length measurements are in inches. Please contact the Authority Having Jurisdic- <br /> tion (AHJ) and review local, state, and national codes to determine the regulatory requirements governing <br /> shut-off capacity in your region, as well as take into account other considerations such as extreme tank tilt. <br /> Desired tank capacity for shut-off: SO%= <br /> Dipstick Number on Tank Chart that corresponds to 100% volume (Y) _ (Y) <br /> Dipstick Number on Tank Chart that corresponds to SO% (X) _ (X) <br /> Upper Tube Reference NumberZ=Y-X (Z) <br /> - 2 <br /> Upper Tube Depth Inside Tank C = Z-2" <br /> (C) <br /> Distance from top sealing surface for 71 SO Lip ' to inside the ® "' <br /> top of Storage Tank2 A= <br /> For NomTestable 71 SO models only <br /> in all cases for non-testable 7150 models, the top of the valve body must protrude at least 61/2" into the tank to <br /> provide a minimal clearance for proper operation3 Additionally the total Upper Tube Length must beat least 16" <br /> of length to include the protective bend in the tube. <br /> Is C less than 61/2 " Yes J No <br /> If NO, Upper Tube Length (D)= C + A <br /> If YES, Upper Tube Length (D)= 6 '/2 "+ A <br /> Upper Tube Length = <br /> For Testable 7150 models only <br /> In all cases for Testable 7150 models, the top of the valve body must protrude at least 61/2" into the tank to provide <br /> a minimal clearance for proper operation .3 Additionally the total Upper Tube Length must beat least 141/2 " of <br /> length to include the protective bend in the tube. <br /> Is C less than 5" Yes / No <br /> if NO, Upper Tube Length (D)= C + A - 1 1/2 If <br /> If YES, Upper Tube Length (D) = 6 '/2" + A - 1 1/2 " <br /> Upper Tube Length = <br /> r Sealing surface may be the top of the Face Seal Adaptor, the built in sealing ledge inside some spill containers, or on non-vapor <br /> tight applications the top of the pipe nipple <br /> 2 Some Underground Storage tanks utilize a manway system at the top. Make sure to use the top of the storage tank for measure- <br /> ment and nor to top of the manway. Consult your underground tank manufacturer for height of the manway <br /> 3 This measurement is taken from the seam where the upper tube is attached to the valve body to the inside of the tank top. <br /> 20 <br />