Laserfiche WebLink
ISD Vapor FlowInstallation <br /> This manual contains instructions to install a Veeder-Root ISD (In-Station Diagnostic) Vapor Flow Meter in a <br /> dispenser's vapor return line in balance systems. <br /> This manual assumes all preliminary site preparation is completed, and that wiring from the console to the Vapor <br /> Flow Meter junction box is in place and meets the requirements set out in the TLS-3XX Series Site Prep and/or <br /> TLS RF Wireless 2 system (W2) installation manuals. <br /> Contractor Certification Requirements <br /> Veeder-Root requires the following minimum training certifications for contractors who will install and setup the <br /> equipment discussed in this manual: <br /> Installer(Level 1)Certification: Contractors holding valid Installer Certification are approved to perform wiring <br /> and conduit routing; equipment mounting; probe, sensor and carbon canister vapor polisher installation;wireless <br /> equipment installation;tank and line preparation;and line leak detector installation. <br /> ATG Technician (Level 2/3 or 4) Certification: Contractors holding valid ATG Technician Certifications are <br /> approved to perform installation checkout,startup, programming and operations training,system tests, <br /> troubleshooting and servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak Detection. <br /> In addition, Contractors with the following sub-certification designations are approved to perform installation <br /> checkout, startup, programming, system tests,troubleshooting, service techniques and operations training on the <br /> designated system. <br /> • Wireless 2 <br /> • Tall Tank <br /> VR Vapor Products Certification: Contractors holding a certification with the following designations are <br /> approved to perform installation checkout,startup,programming, system tests, troubleshooting, service techniques <br /> and operations training on the designated system. <br /> • ISD— In Station Diagnostics <br /> • PMC— Pressure Management Control <br /> • CCVP-Veeder-Root Vapor Polisher <br /> • Wireless— ISD/PMC Wireless <br /> • A current Veeder-Root Technician Certification is a prerequisite for the VR Vapor Products course. <br /> Warranty Registrations may only be submitted by selected Distributors. <br /> Product Marking Information <br /> RELATED DOCUMENTS <br /> Documents Required to Install Equipment <br /> This intrinsically safe apparatus is only for use as part of a Veeder-Root Automatic Tank Gauging System (ATG <br /> Console with probes and sensors).To install intrinsically safe apparatus, use the specific control drawing that <br /> appears on the nameplate of the applicable associated apparatus (ATG Console): <br /> 1 <br />