COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

JSA 05: CUTTING CONCRETE AND PAVEMENT March 30, 2010 Field staff must review job-specific work plan and coordinate with project manager to verify that a// up-front logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts (e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety meeting must be performed and documented at the beoinnin. 0 Job Steps of each workda . Weather conditions heat, 0 Personal Protective Equipment cold, rain, li•htnin. must also 0 Potential Hazard be considered. 0 Critical Actions Mobilize with proper equipment/supplies for cutting concrete and pavement, Gather necessary PPE. Reflective vest for traffic, steel toed and shank shoes, hardhat, safety glasses with side shields, ear plugs/muffs, and leather gloves. Wear an appropriate air purifying respirator with combination organic vapor/HEPA P-100 cartridges, and other PPE as needed for dust. (Use a North respirator or its equivalent, Foam earplugs with an NRR of 33. Tyvek chemical resistant suit or its equivalent), Traffic hazards Vehicle accident. Lifting hazards. Delay or improper performance of work due to improper equipment on site. Start project with Daily Health and Safety Briefing. Follow safe driving procedures. Employ safe lifting procedures. Make sure sub-contractors are aware of their responsibilities for labor, equipment and supplies. Review permit conditions. Develop a traffic control plan with the client/local agencies as applicable. Plan may include use of cones, barrier tape, jersey barriers, etc. Include drawings in the site-specific HASP. It is the responsibility of the SHSO to annotate the Site Plan with the Traffic Control configuration if an Approved Traffic Control Plan is not available. Obtain sub-contractor equipment maintenance records prior to commencing work. Improper equipment maintenance, which can cause equipment failure and possible personal injury. Verify and review maintenance records in possession are for equipment on site. Verify maintenance is current. Set up traffic control, if necessary. See site- specific HASP for detailed plan. Wear reflective vest for traffic; steel toed and shank shoes, hardhat, safety glasses with side shields, and leather gloves as necessary. Struck by vehicle during placement. Vehicle accident as a result of improper traffic control equipment placement. Use buddy system for placing traffic control. Implement traffic control plan such as setting out cones and tape defining safety area. Adhere to approved Traffic Control Plans when working in roadways. (See site-specific HASP). It is the responsibility of the SHSO to annotate the Site Plan with thi Traffic Control configuration if an Approved Traffic Control Plan is not available. Perform concrete and/or pavement cutting. Wear reflective vest for traffic. Wear appropriate hearing protection. Wear safety glasses with side shields, (or face shield), Wear appropriate respirator with HEPA P-100 cartridges and Tyvek suit for nuisance dust. Struck by vehicle during cutting. Noise from cutter. Eye injury from flying debris. Inhalation of dust. Skin irritation from dust. Adhere to approved Traffic Control Plans. (See site-specific HASP). Wear ALL appropriate PPE, safety glasses, hearing protection, etc. Supervisor/HSC must confirm all corings/cutouts Possible injuries and damage to property due to stepping Visually inspect each and every coring or cutout. Paper copies are uncontrolled and are valid only at the time of printing. The electronic version may be downloaded from SGI's intranet. Page 1 of 2 The Source Group, Inc.