COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

ADVISORY - ACTIVE SOIL GAS INVESTIGATIONS 4.2 SOIL GAS ASSEMBLY TESTS Complete shut-in, leak test and purging before collecting soil gas samples after the soil gas well has equilibrated. 4.2.1 Shut-In Test Prior to purging or sampling, a shut-in test should be conducted to check for leaks in the above-ground sampling system. To conduct a shut-in test, assemble the above-ground valves, lines and fittings downstream from the top of the probe. Evacuate the system to a minimum measured vacuum of about 100 inches of water using a purge pump. The test is conducted while the sampling canister, if used, is attached with its valve in the closed position. Observe the vacuum gauge connected to the system with a "T"-fitting for at least one minute or longer. If there is any observable loss of vacuum, the fittings are adjusted until the vacuum in the sample train does not noticeably dissipate. After a successful shut-in test, the sampling train should not be altered. The vacuum gauge should be calibrated and sensitive enough to indicate a water pressure change of 0.5 inches. A shut-in test is not a replacement for a leak test. 4.2.2 Leak Test A leak test is used to evaluate whether ambient air is introduced into the soil gas sample during the collection process. Atmospheric leakage occurs in three ways: Advection through voids in the probe packing material and along the borehole sidewall; Advection directly through the soil column; and Through the fittings in the sampling train at the surface (Banikowski et al, 2009). A leak test should be conducted at every soil gas well each time a soil gas sample is collected to evaluate the integrity of the sample. Introducing ambient air may result in an underestimation of actual site contaminant concentrations or, alternatively, may introduce external contaminants into samples from ambient air. The two types of leak check compounds available for use when soil gas sampling are liquid compounds and gaseous compounds. Both types have their advantages and disadvantages, and practitioners should select a leak check compound based on their project's DQ0s. See Appendix C for quantitative leak testing. 4.2.2.1 LEAK CHECK COMPOUNDS (LIQUID) Liquid tracer compounds, such as hexane, pentane, diflouroethane and n-propanol, can be used to evaluate sample integrity. Other compounds not listed here may also be appropriate. Typically, liquid tracer compounds are applied to towels or clean rags and placed around all connections in the sampling train in order to evaluate potential leaks of ambient air into the sampling train. The liquid tracer should not be directly sprayed or poured onto a fitting, but rather applied to a cloth which should be placed near the connection. Towels or rags with the liquid tracer should also be placed on the ground July 2015 21