COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

ADVISORY- ACTIVE SOIL GAS INVESTIGATIONS adjacent to the probe to evaluate soil column and probe construction breakthrough. The leak check compound selected should not be a suspected site-specific contaminant. Seal integrity is confirmed by analyzing the soil gas sample for the tracer compound. Alternatively, each connection can be individually checked by placing the tracer cloth in a plastic bag and then using the bag to enclose individual connections. Instruments can be used in the field to evaluate whether leakage is occurring rather than waiting for the mobile or stationary laboratory results. Liquid leak check compounds should be included in the laboratory analyte list. The laboratory reports should quantify and annotate all detections of the leak check compound at the reporting limit of the target analytes. If the concentration of the leak check compound is greater than or equal to 10 times the reporting limit for the target analyte(s), then corrective action is necessary as discussed below. 4.2.2.2 LEAK CHECK COMPOUNDS (GASEOUS) Gaseous tracer compounds, such as helium and sulfur hexafluoride, can be used along with a shroud or tent placed over all the sampling equipment. Other compounds not listed here may also be appropriate. Procedures for conducting a quantitative leak test are described in Appendix C. An ambient air leak up to 5 percent is acceptable if quantitative tracer testing is performed by shrouding. 4.2.2.3 LEAK CHECK CONSIDERATIONS A soil gas well should be decommissioned if the leak cannot be corrected. Replacement soil gas wells should be installed at least five feet from the location where the original soil gas well was decommissioned due to a confirmed leak. The leak check compound concentrations detected in the soil gas samples should be included in the laboratory report and the ambient air breakthrough should be discussed in the site characterization report. The intent of the leak check compound is to enhance the integrity of the soil gas sample by demonstrating that minimal or no ambient air breakthrough during sampling is occurring. Although it is preferable not to have any tracer gas breakthrough, minor amounts of breakthrough may be acceptable if the breakthrough is appropriate for the site's DQ0s. Detecting leak check compounds indicate potential field problems. Some potential sources of leaks in sampling trains are poor quality fittings, stripped, over tightened, dirty or worn threads, and excessive sampling train connections. Regardless of the cause of the leak, a data adjustment factor based upon the concentration of the leak check compound to compensate for the inability to collect representative samples is inappropriate. Note that if a passivated stainless steel canister is used to collect a sample that is later analyzed at a stationary laboratory and there is a significant leak, it will typically not be identified until after demobilization of the field crew. Therefore, field screening prior to laboratory analysis is recommended. Commercially available leak check compounds, both liquid and gaseous, may contain unanticipated impurities. Therefore, laboratories should analyze the leak check compound to aid in the interpretation of the data. July 2015 22