Laserfiche WebLink
San Joaquin County Environmental Checklist <br /> Under the Alquist-Priolo Act,faults are zoned, and construction along or across <br /> them is strictly regulated if they are"sufficiently active"and"well defined." A <br /> fault is considered sufficiently active if one or more of its segments or strands <br /> shows evidence of surface displacement during Holocene time(defined for <br /> purposes of the act as referring to approximately the last 11,000 years). A fault is <br /> considered well defined if its trace can be clearly identified by a trained geologist <br /> at the ground surface or in the shallow subsurface, using standard professional <br /> techniques,criteria,and judgment(Hart and Bryant 1997). <br /> Seismic Hazards Mapping Act <br /> Like the Alquist-Priolo Act,the Seismic Hazards Mapping Act of 1990(Pub. <br /> Res. Code Section 2690-2699.6)is intended to reduce damage resulting from <br /> earthquakes. While the Alquist-Priolo Act addresses surface fault rupture,the <br /> Seismic Hazards Mapping Act addresses other earthquake-related hazards, <br /> including strong ground shaking,liquefaction,and seismically induced <br /> landslides. Its provisions are similar in concept to those of the Alquist-Priolo <br /> Act: the state is charged with identifying and mapping areas at risk of strong <br /> ground shaking, liquefaction, landslides,and other corollary hazards,and cities <br /> and counties are required to regulate development within mapped Seismic <br /> Hazard Zones. <br /> Under the Seismic Hazards Mapping Act,permit review is the primary <br /> mechanism for local regulation of development. Specifically,cities and counties <br /> are prohibited from issuing development permits for sites within Seismic Hazard <br /> Zones until appropriate site-specific geologic and/or geotechnical investigations <br /> have been carried out and measures to reduce potential damage have been <br /> incorporated into the development plans. <br /> California Building Standards Code <br /> The State of California's minimum standards for structural design and <br /> construction are given in the California Building Standards Code(CBSC)CCR <br /> Title 24. The CBSC is based on the UBC(International Code Council 1997), <br /> which is used widely throughout the United States(generally adopted on a state- <br /> by-state or district-by-district basis),and has been modified for California <br /> conditions with numerous,more detailed,and/or more stringent regulations. The <br /> CBSC requires that"classification of the soil at each building site shall be <br /> determined when required by the building official"and that"the classification <br /> shall be based on observation and any necessary test of the materials disclosed by <br /> borings or excavations." In addition,the CBSC states that"the soil classification <br /> and design-bearing capacity shall be shown on the(building)plans, unless the <br /> foundation conforms to specified requirements." <br /> The CBSC provides standards for various aspects of construction,including but not <br /> limited to excavation,grading,and earthwork construction;fills and embankments; <br /> expansive soils; foundation investigations;and liquefaction potential and soil <br /> Notice of Preparation for the June 2006 <br /> North County Recycling Center and Sanitary Landfill 2-41 <br /> Permit Revision J&S 06307.06 <br />