Laserfiche WebLink
D Sterilizer operator now uses key to unlock and depress <br /> STERILIZER push button momentarily to start cycle. <br /> Operator now locks and removes key. <br /> After initial vacuum phase is complete, RED Sterilizer Light <br /> will come ON for the remainder of the sterilizing cycle. <br /> Once button is pressed all further operation is automatic. <br /> All above steps are outlined in STERILIZER OPERATION displayed on MAIN <br /> control panel . <br /> 5. Once Sterilizing cycle has reached the end of programmed time setting <br /> RED light will go out and chamber will exhaust itself down to <br /> atmospheric pressure, as will be indicated by pressure gauge located <br /> on control panel . This venting of pressure will also be indicated by <br /> a drop in temperature on the recording chart. <br /> 6. TO OPERATE STERILIZER DISCHARGE: <br /> A. Depress COMPACTOR button to cycle compactor and clear Charge <br /> Chamber for Sterilized material . <br /> B. Depress BLUE Sterilizer Discharge button to begin discharge <br /> cycle. <br /> Chamber will now begin opening and dropping the now <br /> sterilized material into the compactor section. <br /> Once fully open it will shut off and stop. <br /> C. Operator must now open sliding Trash load door and inspect <br /> to see that all material has dropped clear of Chamber <br /> discharge and presents no danger of becoming caught or <br /> pinched in Sterilizer Chamber gasket area once it begins to <br /> close a and reseal . <br /> D. As BLUE Light is still ON with chamber extended, Operator <br /> now depresses BLUE button a second time to begin closing <br /> Chamber. <br /> Once Chamber has completely closed and resealed, unit will <br /> shut off. <br /> E. BLUE Light will now go out and Blue Discharge button will no <br /> longer function. <br /> F. Depress Compactor button now to compact material into <br /> Receiver- Container and clear Charge Chamber. <br /> All controls have no reset and unit is ready to reload. <br />