Laserfiche WebLink
Pep Boys #710 <br />(k)(2)(D) description of any internal and external pumps; Not applicable — there are no pumps on <br />or in the tanks. <br />(k)(2)(E) sketch or drawing of tank including dimensions. See tank dimensions in Table 1, tank <br />drawings in Figures 3, 4 and 5, and photographs of tanks in Appendix A. <br />(k)(3) documented age of the tank system (if tank was previously used), if available, (otherwise, <br />an estimate of the age); The three tanks are 16 years old. See Table II. <br />(k)(4) description and evaluation of any leak detection equipment — describe if any. The tanks <br />are inspected by Pep Boys employees daily and an inspection log is kept. <br />(k)(5) description and evaluation of any corrosion protection equipment, devices, or material: <br />All tanks are located inside a building. They are inspected by Pep Boys employees daily and an <br />inspection log is kept. No corrosion protection equipment or devices are required or necessary. <br />(k)(6) description and evaluation of any spill prevention or overfill equipment. The tanks are <br />inspected by Pep Boys employees daily and an inspection log is kept. <br />(k)(7) description and evaluation of secondary containment for the tank system (secondary <br />containment must meet minimum standards as specified in subsections (j)(1) through (j)(3) of <br />this section) including applicable secondary containment for ancillary equipment as required in <br />subsection 66265.193(f); All tanks are double walled and provide their own secondary <br />containment. See Table V. <br />(k)(8) hazardous characteristics of the waste(s) that have been or will be handled; The waste oil, <br />waste coolant and waste water are California hazardous due to toxicity. See Table 111. <br />(k)(9) prior to placing a new tank system or component in use, an independent, qualified <br />installation inspector or an independent, qualified, professional engineer, registered in <br />California, either of whom is trained and experienced in the proper installation of tank systems, <br />shall inspect the system or component for the presence of any of the following items and <br />document in writing the results of the inspection: The hazardous waste tank system inspection <br />was conducted on February 161h, 2012. See inspector's qualifications in Appendix D. <br />(k)(9)(A) weld cracks or breaks; See Table IV for results of inspection. <br />(k)(9)(B) Scrapes of protective coatings; See Table IV. <br />(k)(9)(C) corrosion; See Table IV. <br />10 <br />