Laserfiche WebLink
p, Alternate construction for new underground storage tanks containing motor vehicles fuel [Section 2633) <br /> (1) Monitoring and response plan [Section 26341 . <br /> (2) Underground storage tank composed of.... <br /> (a) Fiberglass reinforced plastic. <br /> (b) Cathodically protected steel. <br /> (c) Steel clad with fiberglass reinforced plastic. <br /> (d) Other material that complies with section 2631 and 2632. <br /> (3) Floor of leak interception and detection system constructed on a firm base and sloped to a <br /> collection sump (use of membrane liners comply with section 2631 (d) (6) requirements.) <br /> (4) Access casings installed in the collection sump of the secondary containment system with <br /> backfill in the interstitial space. The access casing shall meet all of the following: <br /> _ Designed and installed to allow the liquid to flow into the casing. <br /> r Sized to allow removal of collected liquid and able to withstand all anticipated applied <br /> stresses. <br /> _ Constructed of material that will not be structurally weakened. <br /> _ Screened along entire vertical zone of permeable material. <br /> _ Capable of preventing leakage of any hazardous substance from the casing. <br /> _ Extend to the ground surface and covered with a locked waterproof cap. <br /> _ Capable of meeting S.J. Co. PHS-EHD Well Standards. <br /> _ Leak interception and detection system shall prevent the leaked hazardous substance from <br /> entering ground water. <br /> 14. INTERSTITIAL SPACE MONITORING <br /> A. Visual monitoring [Section 2632 (c) (1)] <br /> (a) Exterior surface and floor beneath tank monitored by direct viewing <br /> (b) Daily visual inspections <br /> (c) Liquid level in tank to be recorded at time of inspection <br /> (d) if liquid observed around or beneath primary tank, owner will determine if an unauthorized releas <br /> has occurred. <br /> B. Mechanical or electronic monitoring [Section 2632 (c) (2)] <br /> (a) Continuous monitoring system connected to an audible and visual alarm system. <br /> Monitoring equipment to be installed 1 <br /> l' Manufacturer: V-k-ej�' - <br /> _✓ Model Number: TL S- 3 SO <br /> _V Sensor Type: _ vapor Liquid Both. <br /> _LI/ Sensor/Panel specifications. <br /> Location s) fQQr sen ors: <br /> Tank S�.tQvST�cIP4�4_ Piping: Sib' <br /> Dispenser:_L <br /> C. Monitoring and response plan submitted [Section 2632 (d) (1) 8 (2)] . <br /> 15. Any special accessories, fittings,( <br /> s, ccojtings, or linings not inherent within the initial design of the 1° tank or <br /> double-wall UST. [Section 26 <br /> A. Approved by a nationally recognized independent testing organization. <br /> B. Demonstration of integrity with the primary and/or secondary containment. <br /> 6 <br />