Laserfiche WebLink
Pre-installation Assembly <br /> Step 1 Step 2 <br /> Install the shear valve mounting 01 After the mounting plate has been <br /> +r� connected to the shear valve, <br /> valve using the three flat-headed <br /> connect the riser pipe to the bottom <br /> plate to a boss mounted shear <br /> of the shear valve. <br /> socket screws provided. Requires <br /> the use of a 1/4"Allen Wrench. <br /> Step 7 <br /> Install the anchor bolts provided in <br /> the specific holes in the mounting <br /> Step 4 <br /> frame to accommodate the model <br /> Install the adjustable Stabilizer Bar <br /> Kits to the side struts of the dispenser to be installed. <br /> dispenser sump. Do not install the <br /> F77- <br /> valve plates at this time. <br /> U r J <br /> Step S <br /> Install the riser pipe/shear valve <br /> assembly to the stabilizer bar <br /> inside the dispenser sump. <br /> Step 5 Sump Access Boot <br /> Install the necessary amount of (Optional) <br /> Conduit Entry Boots into the A 4" boot designed specifically to <br /> desired location on the side of the --- — — -- seal sump access holes which are <br /> dispenser sump. \ drilled to allow for easier installation <br /> inside the sump. <br /> i' Step 6 / <br /> Install the necessary amount of L <br /> Flexible Entry Boots into the <br /> desired locations on the side of the a <br /> 0 <br /> dispenser sump. <br /> 'I I <br /> k Step 3 <br /> Step 9 k Install the elbow connection to the <br /> Connect the coupled piping to the I threaded riser pipe. <br /> plumbing connection inside the <br /> dispenser sump. <br /> Height Adjustability Pipe Entry Locations <br /> All dispenser sumps offer a wide range of height adjustability,if required. The For standard pipe burial applications, the piping should enter at the lowest <br /> easiest means of adjusting the pipe entry height is to install the Flexible Entry possible entry point in the sump. For determining the correct pipe entry loca- <br /> Boot at a higher entry level. If that procedure does not provide adequate entry tion for the dispenser model to be used,refer to the Pipe Entry Guide provid- <br /> height,the riser section can be cut down to the desired height by disconnect- ed with each sump unit. Refer to the Flexible Entry Boot installation instruc- <br /> ing the frame assembly. tions on the next page for proper installation of all pipe entries. <br /> 'L <br /> 12" <br /> 24" <br /> Center Line <br /> Min.Center <br /> Distance is equal to _ _ __ _ ___ __ Entry Line <br /> the outer radius of { <br /> the boot plus 12'. <br />