Laserfiche WebLink
Dispenser Pans <br /> s. <br /> Dispenser Pans <br /> These shallow leak collection containers are designed to accommodate conventional _ o <br /> rigid piping systems. Typical primary P Pa entries into the pan are made with flexible <br /> — <br /> connectors which interconnect the rigid pipe to a shear valve. <br /> Dispenser Pans are fitted with Pipe Entry Boots which directly seal the shear valve to .. <br /> the bottom of the pan. Pans are fitted with a rigid frame,accommodating a wide vari- <br /> ety of dispenser models and pipe entry locations. <br /> Step 1 <br /> Install the shear valve mounting <br /> plate to a boss mounted shear <br /> valve using the three flat-headed <br /> socket screws provided. Requires <br /> the use of a 1/4"Allen Wrench. Step 3 <br /> Connect the flexible connector to <br /> the shear valve and install the <br /> Step 2 assembly down through the Pipe <br /> After the mounting plate has been / Entry Boot after it has been <br /> connected to the shear valve, j installed into the bottom of the <br /> remove the rubber seal from the dispenser pan. <br /> Pipe Entry Boot and install it r` <br /> around the base of the shear valve <br /> before attaching the flexible `` Step 7 <br /> connector. <br /> Install the anchor bolts provided in <br /> the specific holes in the mounting <br /> frame to accommodate the model <br /> dispenser to be installed. <br /> �c" tID <br /> Step 4 ' <br /> Install the adjustable Stabilizer Bar <br /> Kits to the side struts of the <br /> dispenser pan. Do not install the <br /> valve plates at this time. <br /> 1 <br /> -- - <br /> Step 5 <br /> Install the necessary amount of <br /> Pipe Entry Boots into the desired �u:a <br /> location on the bottom of the <br /> dispenser pan. MID <br /> JL <br /> Step 6 <br /> Install the necessary amount of <br /> Conduit Entry Boots into the <br /> desired locations on the bottom of <br /> the dispenser pan. <br />