INSTALL_2001 - Laserfiche WebLink

Home Browse Search

Pipe&Conduit Pipe Entries If Standard Dispenser Pans are ordered,it is necessary to install the Pipe Entry Boots prior to installing the dispenser pan. Included with each dispenser pan is the"Pipe Entry Guide"which contains the pipe entry location points for a variety of dispenser models. The bottom of each Standard Dispenser Pan has two cen- ter reference lines for accurate entry point measurements. Install the Pipe Entry Boots as follows: Step #1 Step #2 Step #3 Step #4 At the measured entry point drill out After the stud holes have been Insert the studded rubber boot into Pre-assemble the shear valve,flex- a 1/4" hole. Fasten the dispenser drilled, remove the Entry Boot the five stud holes from underneath ible connector, Shear Valve pans Entry Boot Templet 11 to the Templet 11 from the bottom of the and then from inside the pan install Bushing and Shear Valve Plate as bottom of the pan,as shown. Next dispenser pan. Using a 2-1/2"hole the corrugated rubber boot onto the shown on page 3. Insert the drill out the five holes for the Pipe saw,drill out the pipe entry opening studs. Next, install the compres- assembly down through the Pipe Entry Boot studs. using the center hole as a guide. sion ring and the nut fasteners. Entry Boot, as shown, and then tighten the band clamp. e� OOl t J- Conduit Entries Conduit Entry Boots must be field installed for both Standard and Custom Dispenser Pans. The Conduit Entry Boot is available in 3/4"size only. For conduit sizes other than 3/4"the Flexible Entry Boots should be installed. Make sure all Pipe Entry Boots are installed prior to installing the Conduit Entry Boots. Step#1 Step #2 Step#3 Step #4 Drill a 1/4"hole at the desired con- After drilling the four stud holes, Insert the Conduit Entry Boot After the Conduit Entry Boot has duit entry point. Install the dis- remove the Entry Boot Templet Il through the opening and stud holes been installed,insert the 3/4"metal penser pan Entry Boot Templet 11 to from the bottom of the dispenser from underneath the dispenser pan. conduit up through the bottom of the bottom of the dispenser pan,as pan. Using a 1-1/2"hole saw,drill From inside the dispenser, insert the boot and then tighten the band shown. Next,drill the holes for the out the conduit entry opening using the metal compression ring down clamp. Note: For conduit sizes Conduit Entry Boot studs. the center hole as a guide. over the studs and then install fas- other than 3/4", use the Flexible teners. Entry Boots. I� ;o 0