Laserfiche WebLink
Bravo PIates <br /> FOR FLUID CONTAINMENT WITHIN HYDRAULIC CABINET <br /> The deflector plates were created in response to certain dispenser designs where components within the <br /> hydraulic cabinet such as the fuel filters have their outer diameters outside of the dispenser footprint mounting <br /> frame and therefore, are located outside of the fluid capture area of either our standard water splash lip on <br /> dispenser frames (frame included with new UDC's) or our CONV-132000 Conversion Frames. In some cases <br /> they are so far out that they are in direct contact with the dispenser door panel, which on some dispenser <br /> models, protrude several inches away from the dispenser footprint O.D. The deflector plates are tailored to <br /> a dispenser series and are affixed to the angled gussets of the footprint frame via a slotted design for easy <br /> removal and replacement. No sealants, nuts/bolts or other fasteners are required. They are not affixed to the door <br /> panels. When slotted into the angled gussets the deflector plates are compressed against the door upon <br /> installation. A foam seal ensures a tight fit and avoids metal-on-metal contact between the deflector plate <br /> and the dispenser door. These deflector plates are designed to run the entire length of the door and fit just <br /> inside the hydraulic cabinet area. <br /> a' V V U V <br /> FUEL FILTER <br /> # DISPENSER <br /> DOOR PANEL <br /> 1 � <br /> ANGLED GUSSETS OF THE DISPENSER FOOTPRINT FRAME 4 4 DISPENSER <br /> FOOTPRINT <br /> FRAME AREA <br /> 6 1 <br /> 1 <br /> 6 1 DEFLECTOR <br /> # PLATE <br /> BEEPIN PEACE # <br /> 1 <br /> ♦ ; DISPENSER OR <br /> � CONVERSION FRAME <br /> SLOTS ON DEFLECTOR PLATE SLOT INTO GUSSETS <br /> UDC BELOW GRADE <br />