COMPLIANCE INFO_2022 - Laserfiche WebLink

Home Browse Search

UL TANK 4 of MONITORING SYSTEM AND PROGRAMMING ims section must be completed it a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? X El El all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freey, ❑ Were all probes reinstalled properly? functional) tested, and confirmed operational? Z E3❑ Were all hems on the equipment manufacturer's maintenance checklist completed? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with ❑ ❑ ❑ their proper operation? ❑X ❑ ❑ Was monitoring system set-up reviewed to ensure proper settings? © El 11Was the monitoring panel's backup battery visually inspected, funMionally tested, and confimred operational? © ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under -dispenser containment? El El the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically disconnected? ❑X ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? Which sensors initiate positive shut down? (Check all that apply.) ❑X Sump ❑X Under -Dispenser Containment ® ❑ ❑ If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) operational? ❑ ❑ X❑ For any answer of "N" above, describe in Section IX how and when these deficiencies were or will be corrected. IX. COMMENTS NO SHUT DOWN ON AST DISPENSER SENSORS, TESTING FOR A T G COMPLIANCE X. IN -TANK GAUGING TESTING ❑XC Check this box if tank gauging is used only for inventory control. (Do not complete this section.) [:]Check this box if NO tank gauging equipment is installed. (Do not complete this section.) Y N NA This section must be completed if in -tank oauoina is used to oerform leak datectinn mnnitnrinn ur-0■n were au m-tanK gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally tested, and confirmed operational? 1 ❑ ❑ 1 ❑ Was accuracy of system's product level readings tested? ❑ I ❑ I ❑ Was accuracy of system's water level readings tested? ❑ ❑ ❑ Were all probes reinstalled properly? ❑ ❑ ❑ Were all hems on the equipment manufacturer's maintenance checklist completed? ❑ ❑ ❑ For any answer of "N" above, describe in Section XI how and when these deficiencies were or will be corrected. XI. COMMENTS Y= Yes, N = No, NA= Not Applicable