SU0015039 - Laserfiche WebLink

Home Browse Search

STANDARDS AND ORDINANCE REQUIREMENTS PA-2200096 ATLAS AIR WORLDWIDE, INC./SIEGFRIED ENGINEERING Improvement Plan Application No. PA-2200096 was approved by the Community Development Department on August 29, 2022. The effective date of approval is August 29, 2022. This approval will expire on February 28, 2024,which is eighteen (18) months from the effective date of approval, unless (1) all Ordinance Requirements have been complied with, and (2) all necessary permits from other agencies have been issued and remain in force. Those requirements followed by a Section Number have been identified as Ordinance Requirements pertinent to this application. Ordinance requirements cannot be modified, and other ordinance requirements may apply. 1. COMMUNITY DEVELOPMENT DEPARTMENT(Contact: [209]468-3121) a. BUILDING PERMIT: Submit an "APPLICATION-COMMERCIAL BUILDING PERMIT'. The Site Plan required as a part of the building permit must be prepared by a registered civil engineer or licensed architect. This Plan must show drainage, driveway access details including gates, on-site parking, landscaping, signs, existing and proposed utility services, and grading (refer to the "SITE PLAN CHECK LIST'for details). Foundation and soils investigation shall be conducted in conformance with Chapter 18 of the California Building Code at the time of permit application. A fee is required for the Site Plan review. (Development Title Section 9-884) b. APPROVED USE: This approval is for a 1,440-square-foot replacement office trailer and a new 320- square-foot storage trailer at an existing air cargo facility located at the Stockton Metropolitan Airport as shown on the site plan dated April 26,2022.(Use Type:Wholesale&Distribution—Light)All aspects of this project shall comply with the standards and requirements contained in the Stockton Metropolitan Airport Special Purpose Plan (SMA SPP)dated October 10, 2000. c. CAPITAL FACILITY FEE:This project may be subject to the Capital Facility Fee. If the Capital Facility Fee is applicable, the County shall collect the fees before the issuance of any building permits. (Development Title Section 9-1245.2) d. BUILDING HEIGHT AND MASSING: The maximum building height shall be 45 feet. Mechanical enclosures are not considered in determining height. (SMA SPP, page IV. 5-2) e. ARCHITECTURAL CHARACTER: 1. Building walls should be articulated to avoid long expanses of flat walls. (SMA SPP, page IV. 5-2) 2. Blank walls shall be prohibited where adjacent to pedestrian ways and should be avoided elsewhere. (SMA SPP, page IV. 5-2) 3. Flat roofs are acceptable, as well as low pitches and barrel vaults. Where pitched roofs are used, the maximum pitches shall be 4 in 12. Parapet screening shall be provided on all sides of flat roof buildings. (SMA SPP, page IV. 5-2) 4. Metal roofs shall be painted with a durable finish. Zinc, copper and similar natural weathering metals are acceptable, but galvalume is prohibited. Built-up roofing is acceptable however coatings must be non-reflective in complementary colors. Asphalt shingles and wood are prohibited. (SMA SPP, page IV. 5-2 and 5-3) 5. Ground floor windows at walls to offices or similar areas should be provided. (SMA SPP, page IV. 5-3) PA-2200096—Standards and Ordinance Requirements 1