COMPLIANCE INFO_2023 - Laserfiche WebLink

Home Browse Search

[Aviv elhe *op Guilt fcbmwm4 igu ammilpidaik bele Align punch with drilled hole STEP 113: rampu FIRST HOLE Remove tool. RemOW any chips or burrs from the drill- ing operation. Place the assembly on solid surface. Using the punch supplied with the 71SO-TOOL, 71 SO- TOO/C, and 71S0-TODLCT. align the tip of the punch wtth the &died hoie and dimple the uFpeq Crop tube by striking the punch with a hammer until the drop tube is formed into countersunk hole in the inlet tube. After purpching, remove any chips that rnay h i ve fallen into the intet tube screw hole. Figure' 13 STEP 14: ASSEMBLE FIRST SCREW Ensure that the drop tube was formed into the counter- sunk screw hole as shown In Figure 14 if not return VI Step 13. Apply black rnoly grease to screw and tighten first screw Into Inlet tube with a screwdriver. Use only the taptite screws that are supplied with the untt. Seat- torque is 20 in-ibs min, ti s in4bs max. Strew bezel should be flush with the drop tube, Do not over tight- en, Figure 14 STEP 13: DIMPLE REMAINING HOLES Remove any chips or burrs from the drilling operation. Dimple the next (2) holes as done in Step 13. Make sure the assembly is on a solid surface when pundang- After punching, temente any chlps that may have fallen into the Net tube screw hole. Figur* 15 STEP 16: ASSEMBLE OTHER SCREWS Apply black rnoty grease to screws and tighten the oth- et (2) screws into inlet tube with a screwdriver as done In Step 14. Use only the tante screws that are supplied with the unit. Seating torque is 20 sn -lbs min. to 35 'n- ibs max. Do not over tighten. STEP 17: APPLY UNEASE TO LOWER 0-11SNG AND BODY THREADS Apply black tnoly grease to the lower tube a-ring and body threads as shown. Make sure coverage is com- pletely wound the 0-ring. ftistIl o-ri no in groove just above threads. Figurei7 Ii