COMPLIANCE INFO_2023 - Laserfiche WebLink

Home Browse Search

Gal ir ,opts only SO-TOOLCT PROCEDURE SELOW, I FOR 71SO-TOOL, SEEPAGE 8 FOR 71SO•TOOLC„ SE/ PAGE 9 STEP 9C: INSERT 71SO-TOOLCT OVER INLET TUBE To install the 7150-TVOLCT (soki sep,i rarely) over the 'inlet tube, first lOcisen The thumb Screws, so the tool can pass freely over the Inlet tube flange. Align the slot on the tool with the key on the Inlet tube and insert the tool down. Sem Figura 9C_ Hand tighten thumb screws k:? Figure ØC Figure 10C sTrry1OC: TIGHTEN THE 71SO-TOOLCT Ensure that the too/ sears flat against the top of the inlet tube TO prevent vertical movement of the tool during chilling, hand tighten the thumb screws against the up- per drop tube. See Figure 10C. STEP 11C.: PREPARE DRILL AND BIT Conform that the stop on the 3/16 &ill bit supplied with the 71SO-TOOLCT 'Is in the correct position before drilling. The stop Is factory installed aa distance be- tween 1-3/16' to 1-1/4" from the tip with the 71SO- TOOLCT. If the stop is not at the correct position it must be fixed before drilling. cAuTtott: it the drill atop is not in the proper too- tio n teiluie of pressure decay leak test may result. Tip to stop dirnero skin must be 1-3/1f5' to 1-1/4' Aye, 77C STEP 12C: DRILL HOLES With the inlet tube and 1150-TOOLCT in place, carefully drill a 3/14* diameter hole In the upper tube using the hole in the 71 50-TOO-LCT as a guide. The dnlfstools posh:oohed SO it wil$ bottom out Againsi the t Dth after the bit has drilled through The upper drop tube. lithe stop is positioned wrong either no ho[e will be drilled, or a through hole couid potentially be drilled through the inlet tube. Ina hole is drilled return to step 11C and ci-teds the stop dimension. If a hotels drilled through The )nlei tube or 'onto the scxew hole the assem- bly is not salvageable. DrIll (2) mole holes in the two remaining guide holes. Figure Loosen thumb screws . • Tool Slot 10