Laserfiche WebLink
Socket <br />adaptor , <br />assembly <br />Trim <br />cal* <br />after <br />Lt-Fr 3T Loop <br />Figure if <br />1 /V mandrel <br />avec <br />Ferruie <br />Cable over float bracket <br />Seam <br />Figure 3T <br /> ..„._ <br />Cable <br />port <br />TESTABLE PROCEDURE ONLY. FOR STANDARD MOD- <br />ELS, PROCEED TO NEXT PAGE. <br />STEP Tr: INSTALL SOCKET ADAPTOR ASSY <br />Put cable thru threads in inlet tube and put thru cable <br />port on side of inlet tube. Thread the socket adaptor <br />assembly finger tight into the inlet tube. Note: the ea- <br />ble port on the inlet tube must be in line with the float <br />as shown previously in Figure 8A. <br />Figune 7T <br />STEP aTi PASS CABLE THRU FERRULE <br />Vats cable thru ferrule. Loop cable and then pass cable <br />back thru ferrule. Keep ferrule loose until cable length <br />is determined in die next step. Note: K cable end frays <br />it may be necessary to trim the table again to pass thru <br />ferrule. <br />STEP 3T: DETERMINE CABLE LENGTH <br />Run cable along u pper tube and over the lop Nate on <br />the float bracket as Shnwn . With the float in the down <br />position (as shown in Figure 3T) align loop in cable with <br />rivet and top hole in float bracket. Use the rivet as a <br />template to size the loop in the cable and ptkil cable <br />tight and crimp ferrule with crimping tool pliers onto <br />cable at this location. Trim excess cable with wire cut- <br />ter scisspi. For reference, from the seam where the <br />upper tube and valve body meet to the end of the cable <br />after trimming will require approximately 35' of able. <br />STEP 41-: ATTAai CABLE TO FLOAT BRACKET <br />Ensure cable Is over the float bracket. Using the sup- <br />plied rivet align loop in cable with top hole in float <br />bracket and pass rivet thru cable loop and float bracket <br />hole. Using rivet too) for yr dia mandrel attach rivet <br />and cable TO the float bracket. See last page for list of <br />replacement cable parts. <br />Attach rivet to top hole <br />FigUlit 4T <br />STEP ST; ENSURE Roopt-R CABLE OPERATION <br />Unthread the socket adaptor assembly from the inlet <br />tune and ensure Rost and 06ppe4 crsowe Gv-ely <br />sorket adaptor assembly is puNeci cm. it should only <br />require .3 to 4" a movement tn order to actuate the <br />float and poppet. Thread socket adaptor assembly fin- <br />ger tight into inlet tube after testing. <br />I 1