Laserfiche WebLink
4-wire receptacle <br />(NEMA type 14-30R) <br />Spade terminals <br />with upturned ends <br />4 prong plug <br />Ring terminals <br />Power Supply Cord Connection <br />Power Supply Cord Strain Relief <br />1. Attach power supply cord <br />strain relief <br />A <br />1.31,1•111•119971•••••••WC <br />Remove the screws from a 3/4" (19 mm) UL Listed strain <br />relief. Put the tabs of the two clamp sections (C) into the <br />hole below the terminal block opening (B) so that one tab <br />is pointing up (A) and the other is pointing down (D), and <br />hold in place. Tighten strain relief screws just enough to <br />hold the two clamp sections (C) together. <br />Strain relief tab pointing up <br />Hole below terminal block opening <br />Clamp section <br />Strain relief tab pointing down <br />2. Attach power supply cord <br />to strain relief <br />Put power supply cord through the strain relief. Be sure that <br />the wire insulation on the power supply cord is inside the <br />strain relief. The strain relief should have a tight fit with the <br />dryer cabinet and be in a horizontal position. Do not further <br />tighten strain relief screws at this point. <br />4-Wire Power Supply Cord Connection <br />IMPORTANT: A 4-wire connection is required for mobile <br />homes and where local codes do not permit the use of <br />3-wire connections. <br />tiz <br />22