Laserfiche WebLink
1. Connect neutral ground wire <br />and neutral wire <br />-1111111111.1111.11MMIINNI <br />Remove center terminal block screw. Remove neutral ground <br />wire from external ground conductor screw. Connect neutral <br />ground wire and the neutral wire (white or center wire) <br />of power supply cord under center terminal block screw. <br />Tighten screw. <br />Center terminal block screw <br />Neutral ground wire <br />External ground conductor screw - Dotted <br />line shows position of NEUTRAL ground <br />wire before being moved to center terminal <br />block screw. <br />Neutral wire (white or center wire) <br />3/4" (19 mm) UL Listed strain relief <br />. Connect ground wire <br />Connect ground wire (green or bare) of power supply cord <br />to external ground conductor screw. Tighten screw. <br />Neutral wire (white or center wire) <br />Center terminal block screw <br />Neutral ground wire <br />External ground conductor screw <br />Ground wire (green or bare) of power <br />supply cord <br />3/4" (19 mm) UL Listed strain relief <br />Connect the other wires to outer terminal block screws. Tighten <br />screws. Tighten strain relief screws. Insert tab of terminal block <br />cover into slot of dryer rear panel. Secure cover with hold-down <br />screw. Now go to "Venting Requirements." <br />3-Wire Power Supply Cord Connection <br />IMPORTANT: Use where local codes permit connecting <br />cabinet-ground conductor to neutral wire. <br />3-wire receptacle <br />(NEMA type 10-30R) <br />3 prong plug <br />Spade terminals <br />with upturned ends <br />Ring terminals <br />. Connect neutral wire <br /> <br />Loosen or remove center terminal block screw. Connect neutra <br />wire (white or center wire) of power supply cord to the center <br />terminal screw of the terminal block. Tighten screw. <br />Neutral wire (white or center wire) <br />Center terminal block screw <br />Neutral ground wire <br />External ground conductor screw <br />3/4" (19 mm) UL Listed strain relief <br />Connect the other wires to outer terminal block screws. Tighten <br />screws. Tighten strain relief screws. Insert tab of terminal block <br />cover into slot of dryer rear panel. Secure cover with hold-down <br />screw. Now go to "Venting Requirements." <br />I- <br />23