Laserfiche WebLink
I <br /> (a) Open sterilizer door. Then, <br /> remove dam gasket (1) and <br /> door gasket (2) from <br /> door (3). 3 A <br /> (b) Clean the gaskets (1 and 2) <br /> with a mild detergent and <br /> inspect the gaskets for --� <br /> cracks, cuts, shrinkage, or <br /> swelling. Replace gaskets if <br /> necessary. <br /> (c) Clean the gasket housing <br /> 1 � <br /> channel (A) with a solution <br /> of mild soap and distilled or Iza <br /> demineralized water. A <br /> small brush (not wire brush) ° <br /> may be used to aid the <br /> cleaning. <br /> (d) Press the door gasket (2) MA438700 <br /> into the channel (A). Then, <br /> install dam gasket (1). <br /> (e) Run one cycle to seat the gaskets properly. <br /> Troubleshooting Guide <br /> Use the following table to assist in correcting minor problems with the sterilizer. <br /> Operator <br /> Troubleshooting Guide <br /> Maintenance <br /> Problem Possible Cause Solution <br /> WATER LOW lamp in not enough water in add distilled or <br /> on. reservoir tank to fill demineralized water to <br /> chamber reservoir tank. <br /> DOOR AJAR lamp is on. Chamber door is not fully Close the door properly and <br /> closed and/or latched. make sure the door is fully <br /> latched. <br /> ERROR lamp is on. _ See Error Code Guide for a <br /> detailed explanation <br /> Steam is escaping from pressure relief valve was Reseat the pressure relief <br /> the pressure relief valve. not properly reseated after valve(see Perform Pressure <br /> pressure relief valve Relief Valve Check under <br /> inspection Monthly maintenance in this <br /> manual). <br /> i <br />