COMPLIANCE INFO_2024 - Laserfiche WebLink

Home Browse Search

STEP 13r DIMPU FUtST HOLE STEP 13: DIMPLE REMAINING HOLES Rove fool. Remove any chips or burrs from the drill- Remove any chlps or burrs from the drilling operative. ing operation. Place the assembly an a solid surface. Dimple the next(Z)holes as dome in Step 13. Make wre Using the punch supplied with the 7 i SO?OOL, 71 SO- the assembly is on a solid surface when punchi ng_ After TOMC,and 7150-7001-CT,align the tip of the punch punching,remove any chips ttiat may how fallen into with zhedrriied hofe and dhnple the u pe+ drop tube by the inlet tube screw hole. striking the punch with a hammer until the drop tube h, formed into countersunk hole in the inlet tube, After puncfiing,remove any chrps that may have fallen into the ink-t tube screw hole. Align punch with drilled ho4e I • figure 15 STEP 14: ASSEMBLE MBLE OTHER SCIE'WS Apply black rttoty grease to screws a nd tighten the Qth- er(Z)screws into in let iuibe with a screwdriver as done figure 13 in Step 1 it, Use only the mpbte screws that are w pplied wiTh rtwe unit. Seating torque Is 20 in-Itn min_to 35 in.. STEP 14: ASSEMBLE FIRST SCREW lbs max. Da not over tighten. Ensure that the drop tube was formed surto thw cou nter- sunk screw We as shown In Figure 14 if net return to S71P 17: APPLY GREASETd LOW0110-#MNG AND Step 13. Apply black molly grease fav screw and tighten 8MM THREADS first screw Into Inlet tube with a screwdriver. Use only Apply black molt'grease to the bwer tube u-ring and the taptite screws that are supplied with titre unit Seat- body threads as shown. Marks sure coverage is com- ing torque is 24 in-lbs rnin.ta 3S in-lbs max_ Screw head pletelyanaund The i?.-ring. InaUll o-rirxj in groove just should be flush withtht-droptube, Vo not ower tlght- above threads. en. . . Apply grease around gyring w...araon.�ca�.�►iso �{ing figure 14 groove sc►dyttneacfs f/gum 17 I1