SU-2601188_SSCR - Laserfiche WebLink

Home Browse Search

RESTRICTED MATERIALS PERMIT#39-23-3904333 Page 12 of 14 MANNA RANCH INC Expires: 12/31/2023 than thirty-three(33)percent of the distance between rows is treated. Appendix C General Drift Minimization General Drift Minimization See attached:Appendix C Appendix H Aluminum Phosphide and Magnes Aluminum Phosphide and Magnesium Phosphide for Burrowing Rodents See attached:Appendix H QL DICAMBA AND PHENOXY HERBICIDES CONDITION-QL-DICAMBA AND PHENOXY HERBICIDES-North of Eight Mile Road In addition to all applicable laws, regulations and label restrictions, the CONDITIONS BELOW APPLY to applications covered by this permit. 1. No ester formulation applications allowed. 2. Do not discharge material more than 10 feet above the crop or target. 3. A drift reducing agent shall be added to the spray mixture at label rates. 4. Maximum wind velocity for Phenoxy herbicides is 10 m.p.h. 5. Maximum wind velocity for Dicamba is 10 m.p.h. EXCEPT when wind is moving in direction of sensitive crops, then the maximum wind velocity is 5 m.p.h. 6. No Dicamba or Phenoxy herbicide applications are allowed beginning March 16 and continuing through October 15, or longer until grape leaves in the vicinity of the treated area are"browned off'. P General Conditions CONDITION -P-General Applicators should consider viable alternative methods prior to any pesticide use. The following conditions apply to applications under this permit.Applicators must additionally follow all applicable laws, regulations, label restrictions and other more restrictive conditions of this permit. 1. Maximum wind velocities for applications of Restricted Materials unless otherwise covered by the label, law, regulation,other permit conditions or environmental conditions at the application site are: a. Spray- 10 m.p.h. b. Dust-8 m.p.h. c. Pellets, granular or baits- 16 m.p.h. 2. Unless specifically named as a dust on this permit, NO DUST FORMULATIONS are allowed. 3.Apply pesticides covered by SLN(s)and Section 18(s)in conformance with the SLN(s)and Section 18(s). The SLN and/or Section 18 must be present at the use site along with the registered label. 4.A flagger is required at the application site for all AIR applications of Zinc Phosphide bait. 5.The applicator shall submit Notice of Intents (NOls)for any California Restricted Material to be used. NOls will only be accepted electronically(CalAgPermits), in-person,or over the phone. NO NOI will be accepted by email or fax. NOls, in any submitted form, for weekend applications will NOT be accepted after 12:OOpm Friday.Any California Restricted Material application proposed before 12:OOpm Monday must have the corresponding NOI submitted no later than 4:OOpm the prior Friday. EPA Registration Numbers for the proposed material to be used should be submitted on the NOI form.