SR2400641 - Laserfiche WebLink

Home Browse Search

KLE/NFELOER (�H e a l t h& Safety Procedure HSP-3-02 Version 11 GENERAL SAFETY Number: Number: PROCEDURES Published 6/15/2018 Revised 3/12/2019 Date: Date: • Inspect tools frequently for defects. Turn in all tools which are burred, broomed, mushroomed, have split or loose handles, worn or sprung jaws, generally unsafe, etc. • Use tools properly; do not use a wrench for a hammer, a screw driver for a chisel, pliers for a wrench, pipe or Stilson wrenches as a substitute for other wrenches, a pipe handle-extension or"cheater" on a wrench, etc. • Do not lift or lower portable electric tools by means of a power cord, use a hand line. Likewise, never throw tools, equipment, or material up or down from one working level to another, always use a hand line. • Keep cords of electrical equipment coiled when not in use. When in use, make sure cords are positioned to avoid being run over by vehicles or equipment. • When using any electrically-powered equipment, make sure it is properly grounded by using 3-wire receptacles and extension cords, and a properly grounded source. ❑ Shut down and lockout/tagout machinery before cleaning, oiling, or adjusting. • Never leave nails or spikes protruding from planks, boards, or other timbers. Pull them out or clinch them (bend them over) into the wood. • Do not operate machinery or equipment without proper training. • Do not wear loose or frayed clothing, dangling ties, finger rings, etc. when operating or working near moving machinery or other mechanical sources of entanglement. • Do not attempt to repair or adjust machinery while in operation, nor attempt to oil moving parts, except on equipment that is designed or fitted with safeguards to protect the person performing the work. • Do not work under vehicles supported by jacks or chain hoists without protective blocking that will prevent injury if jacks or hoists should fail. • Air hoses should not be disconnected at compressors or from tools until the hose line has been bled. • Do not operate hand or power tools for which you have not been trained. 3-02.5 General Safety Rules General office safety rules are addressed in Section 3.8.6 of this Manual. 3-02.6 Visitors to Construction Sites • Read the site-specific HASP and understand the site safety rules Copyright 2019 Kleinfelder, Inc. Page 3 of 4 Important: When modifying this document, update properties with your name, date, and nature of changes made.