Laserfiche WebLink
OR Levine+ncke <br /> Revised <br /> • 8.2 GOS Pilot Test <br /> Overview <br /> Ozone has proven to be effective in destroying a wide variety of organic chemicals, <br /> including chlorinated VOCs Ozone sparging is an in situ remediation technology for <br /> VOCs in groundwater The technology uses a variation of the aur sparging process and <br /> consists of sparging of small ozone-contauung nucroporous bubbles into the saturated <br /> zone The sparguig of ozone gas in micro-parous bubbles maximizes the contact <br /> between the ozone bubbles and VOCs in groundwater Ozone is an oxidizing gas that <br /> detoxifies chlorinated compounds such as PCE by decomposing them into byproducts <br /> such as carbon dioxide and very dilute HCl, which then react to form mineral salts <br /> Unlike air sparging techniques, this technology usually does not require vapor control <br /> because oxidation reactions are completed before vapor flow reaches the unsaturated <br /> zone Therefore, little or no untreated emissions enter the overlying soil However, <br /> LFR will collect data during the pilot test to confirm that the SVE captures any <br /> untreated vapors that may enter the vadose zoite and to verify that SVE is not necessary <br /> for full-scale ozone sparging unplementation- In addition, the combined SVE/GOS <br /> Phase IV pilot test will provide data to assess the suitability of the technologies to <br /> remediate both the vadose zone and the shallow groundwater beneath the Guild <br /> Gleaners Property. <br /> LFR proposes to use a self-contained ozone-air sparging system used during the Phase <br /> III pilot test for the Phase IV GOS testing During the Phase III test, only the air <br /> sparging component of the C-Sparge system will be used However, during the Phase <br /> IV SVE/GOS pilot test, the ozone generator within the sparge system will be put into <br /> use and ozone will be sparged into the shallow-zone groundwater <br /> Microporous ozone bubbles will be sparged through tubing to the sparge point that is <br /> designed to generate very small bubbles, i e., approximately 50 micrometers in <br /> diameter Micro bobbles will be forced out into the surrounding water-bearing <br /> formation The control panel within the sparge system will be used to regulate the <br /> frequency/duration of ozone sparging and on/off sequencing of sparging Microporous <br /> ozone bubbles sparged into the formation will come into contact with affected <br /> groundwater, where contaminants in groundwater will be oxidized and volatilized into <br /> the air bubble and will be carried to the vadose zone where it will be captured by the <br /> SVE system <br /> The pnmary tool for developing design requirements for a GOS system will be the pilot <br /> testing program described in the following sections The GOS pilot testing program is <br /> proposed at the locations depicted on Figure 10 The well locations in which ozone <br /> sparging will be conducted are described in Section 8 3 <br /> 8.3 Dual-Purpose SVE/Sparge Well Equipment <br /> The wells to be used us the Phase IV pilot test program will be the nme wells mstalled <br /> as part of this pilot test program plus existing groundwater momtonng wells MW-09 <br /> WPSV cs Lad,-mv-N123 doc irr <br /> 02/so d 8€T0b9b60Et 01 906V ZS9 01S BA31 =J 3NIA3-1 831 dd ep 9I 20, 60 -fnr <br />