Laserfiche WebLink
B.5) The main fitting body (Item A) should be installed to ' t�erstitial Test Port <br /> the outside first. Then apply adhesive as shown (Fig. 135).� ( my on Flange) <br /> . A _ r ` <br /> - / Adhesive` <br /> Injection <br /> The Adhesive Injection Port on the fitting body / Port <br /> must be at the 12-o-Clock or North Position. i <br /> The Interstitial Test Port on the Flange <br /> must be at 12-o-Clock or North Position. (Fig X) <br /> Fig. B5 Fig B8 <br /> Adhesive Fill & <br /> Bead <br /> Here <br /> 360° <br /> Item B <br /> Item A (Flange) <br /> (Main bodt <br /> ri <br /> Adhesive <br /> OUTSIDE <br /> Install Main body to outside of sump Install the loose Flange <br /> and apply adhesive to areas shown and use gloved finger to run a <br /> generous bead along joint. <br /> B.6) Apply adhesive to the Main Body's outer surface 360° where shown. Fig. B7 <br /> After applying adhesive to all contact areas (Fig. 135)Apply the flange over <br /> the fitting and to the wall (Item B, Fig. 13.5) <br /> B.7) Apply the Bravo Clamp immediately as shown in Fig. 137. Install clamp e`, t <br /> shown to the body roughly 1/4" from the face and tighten. Then hand-tighten ' <br /> each bolt so it is snug.Apply a 1/4 - 1/2 turn to each bolt evenly until the a - <br /> clamp starts to slide away from the wall and flush with the face of the.fitting. :LAMP <br /> INSIDE <br /> B.8) Apply a generous bead of adhesive as shown. (Fig. B8). <br /> B.9) Glue all penetration fittings and allow to cure following the <br /> pipe manufacturers adhesive instructions. <br /> 7 ii-F-Series-1 X-SS-D-11 A <br /> I <br />