Laserfiche WebLink
5. (Vote: (Radial Combo & Petro Cables Only) illustration 2 <br /> Before the tanks standpipe is attached to <br /> the tank's monitor fitting, it is necessary to ryylon Cord <br /> fish a nylon cord into and around the tank's <br /> interstitial space. Once the loop is com- <br /> plete, pull the cord through the detached <br /> monitoring pipe. Next„ attach the standpipe <br /> to the tank. The purpose of the nylon cord is <br /> to pull the Radial Cable around the tank at a <br /> later time. (Illustration 2) <br /> F <br /> t <br /> 1 1. <br /> f <br /> Installing Connector & <br /> Monitor Cable <br /> All Connector & Monitor Cables are pulled through the 11/2" conduit using an "Electricians Fish." <br /> Care must be taken not to damage the cable during this procedure. <br /> Starting at the monitor, insert the electrician's fish down into the conduit and out towards the first <br /> monitoring station. pull <br /> At the first monitoring station attach the bare end of the Monitor Cable tobltthe end � � fish a td Cut <br /> the cable to the monitor. At this time, pull all but 12 of the excess g <br /> monitor leaving 12" of slack at the first monitoring sta- <br /> the cable to the appropriate lengths at the <br /> tion. (Illustration 3) ring <br /> Repeat the previous procedure starting at <br /> tsthe first <br /> i s Almylways attachtand poation ol1 the install <br /> male plug of the � <br /> between the first and second monitoring <br /> Connector Cable through the conduits. Make sure there is always a male and female plug in <br /> each cross fitting. (Illustration 4) <br /> .--cap <br /> ~Cap miia <br /> Connector Cable Monitor Cable <br /> �Mont for Calle <br /> it <br /> i <br /> r! <br /> male b 1 <br /> i X71 ug End <br /> b <br /> " II Female <br /> R Cl ug End <br /> q Plug End Conduit <br /> Conduit u - <br /> n <br /> — — :nd <br /> y-- Monitoring Cross Fitting <br /> Cross Fitting well <br /> nantar <br /> Illustration a <br /> Illustration 3 <br /> —10— <br />