Laserfiche WebLink
Elf rED <br /> E- Upper Frame Installation FEB 162017 <br /> ENVIRONMENTAL HEALTH <br /> EA - Clean all surfaces. Apply a generous bead of <br /> provided Vulkem to the top edge of the Midframe. Be ,3600 1g• <br /> sure to apply Vulkem to the bolt holes. (Fig. E.1) Seat <br /> a <br /> E.2 - Place the dispenser frame on top of the <br /> midframe and align the holes. Secure using provided <br /> truss head screws. Apply Vulkem to threads and <br /> between parts you are bolting to.Apply Vulkem to the <br /> external gap between the midframe and upper Midframe <br /> frame. After tightening bolts and/or nuts provided and <br /> upper frame is secure, apply generous amount of <br /> vulkem to seal the nut and threads. <br /> E.3 - Loosen valve bolts on bracket to allow for <br /> adjustability for when you align dispenser and make <br /> valve connections. <br /> While it is common to bead silicone caulk or other sealant along <br /> I j the bottom edge of the dispenser paneling where it meets the <br /> island YOU SHOULD NOT DO THIS !! <br /> Bravo Systems dispenser frames and conversion frames are purpose built with a tailored Water <br /> Splash lip to prevent water from water entering the bottom seams of the dispenser and into the sump <br /> below. When you seal this edge, it will cause water from rain or heavy fog to accumulate on the inte- <br /> rior of the dispenser and, when it runs down the interior of the dispenser panels, it will accumulate <br /> between your seal and our water splash lip, and drain into the sump causing an alarm. If you MUST <br /> seal this area on the traffic-facing sides of the dispenser, we suggest leaving a 2-3" gap on the ends <br /> to allow water drainage from within. <br /> Island, UDC and Dispenser Frame installed <br /> and ready for dispenser mounting. <br /> 12 ii-B8000-9000-DW-11B <br />