REMOVAL_2003 - Laserfiche WebLink

Home Browse Search

Spec No. CGT-TRACY-UST-01-2003 General Requirements 01010-2 F. Information and Visit to work site: For information pertaining to the Specification and Drawings, or for appointment to visit the work site, Bidder shall contact: INFORMATION VISIT WORK SITE Gary Pforr Same 1030 Detroit Avenue Concord, CA 94518 (925 ) 674-6707 G. Schedule: The schedule shall be discussed at the mandatory Pre-Bid meeting(see Invitation to Bid Letter, for specific date, time and location)in detail. Include with your Proposal a simple bar chart schedule illustrating the relative durations of major activities involved in removal of the two fuel UST's. H. Work Included: The Contractor shall remove two underground storage tanks in accordance with the terms of this Specification and accompanying drawings. The Work to be performed by Contractor shall include, but is not limited to, the following principal items listed below. Detailed requirements are presented elsewhere in this Specification and as shown and described on the Drawings. 1. Scope of Work Summary Remove One 3,000 Gallon Underground Unleaded Fuel Tank and One 3,000 Gallon Underground Diesel Underground Fuel Tank: • Apply for, and coordinate all permits and inspections. • Saw cut pavement surrounding the area to be excavated. • Install engineered shoring, terracing, or sloping per CAL OSHA requirements. • Install safety construction fencing and barricades. • Excavate, stockpile, sample, and test back fill material. • Sample and test underlying soils and/or water under supervision of geologist(furnished by Contractor). i.e. One sample from beneath each end of each tank, one sample from beneath each of the two fuel dispensers at a depth of approximately 3 feet(at the native soil interface), two composite samples from spoil pile, and one sample for each 20 linear feet of piping. • Transport, and dispose of excess clean spoil. • Excavate, stockpile, and load up to twenty(20) cubic yards of petroleum-contaminated soil (trucking and disposal furnished by PG&E, scheduled by Contractor). Note: Handling of greater than 20 CY of contaminated soil will be considered additional work. • Clean and Inert tanks, piping, and dispensers (PG&E will furnish transportation and disposal of rinsate, vacuum truck to be scheduled by Contractor). • Remove, and load tanks (trucking furnished by PG&E and scheduled by Contractor). • Arrange and pay for decontamination and recycling of tanks, dispensers, and steel piping as scrap metal at a facility approved by PG&E. • Cut, crush, and place fiberglass petroleum piping into D.O.T.-approved hazardous waste storage drums and turn over to PG&E for disposal as hazardous waste. • Dismantle contents of fuel island booth. • Remove and dispose of electronic UST monitoring equipment. • Remove and dispose of electrical sub-panel.