REMOVAL_2003 - Laserfiche WebLink

Home Browse Search

Spec No. CGT-TRACY-UST-01-2003 General Requirements 01010-5 become the property of the Contractor,transportation and disposal of waste material and debris shall be the sole responsibility of the Contractor and shall be done at their sole expense. C. Work Assignments: The organization of this Specification into Divisions and Sections and the arrangement of the Drawings shall not control the Contractor in dividing the Work among subcontractors or in establishing the extent of work to be performed by any trade. The use of subcontractors does not relieve Contractor of the responsibility to perform all work under this Specification. D. Project Meetings: Contractor shall attend project meetings at regular intervals mutually agreed to by PG&E and Contractor. Attendance shall be limited to the Contractor and their immediate subordinates. Contractor shall keep meeting minutes with copies sent to all attendees. Meetings shall be held in quarters agreed to by PG&E and Contractor. E. Defective Work: Any work, material, or equipment which does not comply with the requirements of the Contract documents shall be repaired or replaced immediately by and at the sole expense of the Contractor. F. Inspection: Field inspection and tests performed by PG&E does not relieve Contractor of its responsibility to notify and coordinate with City, State, Federal, and all other agencies having jurisdiction over the Work being performed by the Contractor and its subcontractors specified by this Specification. G. Delivery and Care of Material and Equipment: The receiving, storage, quality, and inventory control of equipment and materials required for the Work hereunder shall be the sole responsibility of Contractor. All Work performed by Contractor hereunder shall be done to the satisfaction of PG&E, but this shall not be construed as to relieve Contractor of the responsibility to complete and guarantee the Work as specified. 1. Access: Equipment,tools, and materials shall be transported to and from the property during regular working hours, unless otherwise permitted by PG&E. 2. Storage: Equipment, tools, and materials may be stored on PG&E's property in locations designated by PG&E. H. Obstructions: Contractor shall remove or relocate existing obstructions as necessary to perform the Work subject to obtaining PG&E's permission prior to removing or relocating any obstruction. Removed obstructions shall be repaired or replaced at Contractor's sole expense as directed by PG&E. I. Patching: Contractor shall patch or repair floors, walls, and ceilings as necessary. Material used in patching and repair work shall match the existing finish as closely as possible and must be approved by PG&E. Joints between old and new work shall be made as inconspicuous as possible. J. Openings: Contractor shall construct openings in walls and floors that are necessary for electrical, mechanical, and other work included in this Specification. Openings occurring for removal of obstructions or from relocated work shall be patched and made to appear as inconspicuous as possible. Care shall be taken in cutting existing concrete, plaster, masonry, or other material to avoid damage to a larger area than necessary. Cuts shall be made with an abrasive saw, and where the material thickness is greater than 3/4 inch,the surface shall be scored to obtain a straight cut. Unnecessary cutting or damage will not be tolerated.