REMOVAL_2003 - Laserfiche WebLink

Home Browse Search

Spec No. CGT-TRACY-UST-01-2003 General Requirements 01010-12 7. No change shall be made by the Contractor in any submittal after it has been accepted by PG&E. 8. If the submittal shows any variation from the Contract requirements because of standard shop practice or other reasons, Contractor shall make specific mention of each variation in their submittal in order that, if acceptable, suitable action may be taken for proper adjustment of the Contract; otherwise, Contractor shall not be relieved of the responsibility for the submittal that has been accepted. 9. It is expressly understood that PG&E's review of the submittals shall not relieve the Contractor of any of its responsibilities under this Specification for the successful completion of the Work in conformity with the requirements of the Specification. Such review shall not operate to waive any of the requirements of the Specification or relieve the Contractor of any obligation there under; defective work, materials, and equipment may be rejected notwithstanding such review. B. Procedures: All submittals shall be identified and have the following information: 1. Project name, location, and PG&E Specification Number. 2. Subcontractor's, vendor's, and/or manufacturer's name, address, and telephone number. 3. Submittal number. 4. Project identification. Where product data contain more than one product, model, selection, etc., clearly mark and identify the information intended to be reviewed by PG&E. 5. Reference to drawings and/or Specification sections as applicable. 6. Contractor's stamp of approval with date and initials of person approving the submittal. C. Approval Procedure: Original submittal of four prints will be checked by PG&E and the prints stamped indicating results of checking and what action shall be taken by Contractor. Contractor shall make corrections and incorporate PG&E comments and return final copy to PG&E. D. Use of Submittals: 1. Work shall be fabricated, constructed, and furnished in accordance with the acceptable submittals; one copy of such acceptable submittals shall be kept at the work site. 2. Contractor shall not use any unacceptable submittals or submittal materials without the stamp of acceptance for reference in doing any work. 1.11 FINAL ACCEPTANCE A. General: Contractor must meet each of the conditions below,to the satisfaction of PG&E before final acceptance of the project and issuance of a Final Certificate of Payment. These conditions are listed below. B. Final Cleanup: Immediately prior to Contractor's request for final inspection of the Work or any portion thereof, final cleanup shall be performed by Contractor. In addition to the normal "broom- clean" requirements, Contractor is responsible for assuring that the exposed surfaces of the following materials shall be cleaned as listed herein: