Laserfiche WebLink
Page 6 of 9 <br /> A 7. UN,_, R-DISPENSER CONTAINMENT( TESTING <br /> Test Method Developed By: ❑UDC Manufacturer ®Industry Standard ❑Professional Engineer <br /> ❑ Other(Specify) <br /> Test Method Used: F]Pressure <br /> Vacuum ®Hydrostatic <br /> ❑ Other(Specify) <br /> Test Equipment Used: See attached testing procedures. Fquipment Resolution: <br /> UDC#9/10 UDC#11/12 UDC # UDC# <br /> UDC Manufacturer: - <br /> UDC Material: Plastic Plastic <br /> UDC Depth: 26" 26" <br /> Height from UDC Bottom to Top 8" 8" <br /> of Highest Piping Penetration: <br /> Height from UDC Bottom to 4" 4" <br /> Lowest Electrical Penetration: <br /> Condition of UDC prior to Fair Fair Fair Fair <br /> testis <br /> Portion of UDC Tested Above highest Above highest Above highest Above highest <br /> penetration penetration penetrationpenetration <br /> Does turbine shut down when <br /> UDC sensor detects liquid(both ❑Yes ❑No®NA Dyes❑No®NA ❑Yes El No®NA ❑Yes ❑No®NA <br /> roduct and water)? <br /> Turbine shutdown response time <br /> Is system programmed for fail- ❑Yes ❑No®NA ❑Yes❑No®NA ❑Yes ❑No®NA ❑Yes ❑No®NA <br /> safe shutdown?* <br /> Was fail-safe verified to be ❑Yes ❑No®NA Dyes❑No®NA ❑Yes ❑No®NA ❑Yes ❑No®NA <br /> operational?* <br /> Wait time between applying <br /> pressure/vacuum/water and 30 minutes 30 minutes 30 minutes 30 minutes <br /> starting test <br /> Test Start Time: 2:21 m 2:18pm <br /> Initial Reading(Ri): 1.4212 3.9588 <br /> Test End Time: 2:36pm 2:33pm <br /> Final Reading(RF): 1.4214 3.9589 <br /> Test Duration: 15 min 15 min 15 min 15 min <br /> Change in Reading(RF-Rt): 0.00024 0.00011 <br /> Pass/Fail Threshold or Criteria: 0.002 0.002 0.002 0.002 <br /> Test Result: ® Pass ❑Fail DI Pass Fail ❑ Pass El Fail Pass Fail <br /> Was sensor removed for testing? I ®Yes❑No ❑NA ®Yes❑No ❑NA ®Yes❑No❑NA ®Yes❑No❑NA <br /> Was sensor properly replaced and <br /> ® <br /> verified functional after testing? El ® [-INA❑No NA Yes❑No NA ®Yes❑No❑NA ®Yes [-]No❑NA <br /> COMMentS—(include information on repairs made prior to testing, and recommended follow-up forfailed tests) <br /> i If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an <br /> asterisk(*)is"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160) <br />