WORK PLANS - Laserfiche WebLink

Home Browse Search

Field staff must review job-specific work plan and coordinate with project manager to verify that all up-front logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts(e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety meeting must be performed and documented at the beginning of each workday. Plan, Prevent, Execute (PPE)/Safe Performance Self Assessment(SPSA) procedures must be used throughout the project. Weather conditions (heat, cold, rain, lightning) must also be considered. Each employee is empowered, expected, and has the responsibility to stop the work performed by him/herself or another co-worker if the working conditions or behaviors are considered unsafe.All employees should act proactively to identify.and miti ate hazards to the safest extent of their ability. . . IBM 1! MEN Purge well(s) and collect Steel ffitoedand shan"shoes, Cros s-contamination. • Decontaminate purging equipment between each sampling purge water. Purging of the long sleeve shirt, hastrain, inhalation or location. (Disposable equipment decontam will be properly disposed wells can be done by using safety glasses with seermal exposure to of. Reusable equipment will be washed in an Liquinox wash, rinsed one of four methods, by shields, hearing protection, chemical hazards, slip and with tap water, then rinsed with a de-ionized or distilled water rinse. hand bailer, dedicated reflective safety vest, and `4 fall. Spilling contaminated Wash/rinse water will be transferred to 55-gallon drums and staged pump, a battery operated leather gloves for the non- water. out of way of vehicular traffic-STANTEC/Contractor. pump, or vacuum truck. If chemical aspects of work as a hand bailer, dedicated necessary. If you suspect that • Use proper lifting techniques STANTEC/Contractor. pump, or battery operated equipment is contaminated, pump is used (see below if wear chemical resistant gloves. • Perform air monitoring in accordance with Section 12 -STANTEC using a battery operated Wear appropriate air-purifying pump), collected water will respirator with combination • Have appropriate respirator with combination organic vapor/P-1 00 be transferred to 55-gallon organic vapor/P-100 cartridges cartridges within 3-5 feet of working location, readily available- drums. If the vacuum truck as needed:Wear appropriate . �' STANTEC/Contractor: is used there will be no chemical resistant suit as • Keep work area clear of tripping or slipping hazards- collected water. needed. F STANTEC/Contractor. • Store purge water in 55-gallon drums. . Drums will be staged out of way of,vehicular traffic-STANTEC/Contractor • Drums containing flammable/combustible liquids or solids must be grounded and if there are multiple drums bonded together ST_ANTECIContractor. • Use extreme care when opening the bung caps. Stand an arms length away and open the bung slowly to relieve any built up pressure- STANTEC/Contractor STANTEC Consulting Corporation 13-1.4