WORK PLANS - Laserfiche WebLink

Home Browse Search

Field staff must review job-specific work plan and coordinate with project manager to verify that all up-front logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts(e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety meeting must be performed and documented at the beginning of each workday. Plan, Prevent, Execute(PPE)/Safe Performance Self Assessment (SPSA) procedures must be used throughout the project. Weather conditions(heat, cold, rain, lightning) must also be considered. Each employee is empowered, expected, and has the responsibility to stop the work performed by him/herself or another co-worker if the working conditions or behaviors are considered unsafe.All employees should act roactivel to identlfv and miticiate hazards to the safest extent of their ability. IN . 7shoes, Purge wells using a battery Steel toed andrelectrocution, rical shock, • Currently STANTEC is using 12 Volt Direct Current (DC) operated pump long sleeve shfirehazards, submersibie pumps (model: Tempest Proactive Environmental safety glasses -contamination. Products www.gopronow.biz). USE BATTERY CLAMPS ONLY ON shields, hearing protection, THIS PUMP-STANTECI reflective safety vest, and • The manufacturer recommends a minimum 12 volt to maximum'15 leather gloves for the non- volt DC power supply. DO NOT PLUG INTO ATERNATING chemical aspects of work as CURRENT(AC) OUTLET-STANTEC? necessary. If you suspect that • The manufacturer recommends using a mobile battery power pack, equipment is contaminated, gas generator or vehicle battery to power the 12 volt DC submersible wear chemical resistant gloves. pump- STANTEC. Wear appropriate air-purifying • When using a vehicle battery power supply it is important to turn respirator with combination on the vehicle and run for 2 minutes every 30 minutes in order to organic vapor/P-100 cartridges maintain charge in the vehicles battery-STANTEC. as needed.Wear appropriate chemical resistant suit as • Prior to inserting the pump into the well, connect the pump to a,. nitrile gloves, Traffic Vest, needed. Level PPE with length of 318-inch id low or medium density polyethylene tubing- ;' STANTEC. Exclusion Zone Equipment, • These pumps are designed for minimum 2-inch diameter wells. Leather Work Gloves. Lower the pump into the well so that the pump intake is submerged. (Higher pump rates will be achieved when the pump is lowered near . the bottom of the well, but not the end of the well)__STANTEC.. k • Connect the pumps negative alligator clamp securely to the negative-term inal_omthe.power supply:Then connect the positive clamp to the positive terminal. The pump should now be energized. Continuous pump operation is suitable when placed in water. If running dry, damage may occur within two hours of continuous use- STANTEC. • When purging of the well is completed, disconnect the pump from the power supply by first removing the positive clamp and then the negative clamp-STANTEC. • When the pump is removed from the well, hold the pump in the upright position so that all water is drained from the unit-STANTEC. Decontaminate the pump by immersing into a bucket of warm water with non-phosphate detergent. Attach the pump to the power supply and allow the cleaning the pump. Repeat with clean water-STANTEC.