WORK PLANS - Laserfiche WebLink

Home Browse Search

Field staff must review job-specific work plan and coordinate with project manager to verify that all upfront logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts (e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety. meeting must be performed and documented at the beginning of each workday. Plan, Prevent, Execute (PPE)ISafe Performance Self Assessment(SPSA) procedures must be used throughout the project. Weather conditions(heat, cold, rain, lightning) must also be considered. Each employee is empowered, expected, and has the responsibility to stop the work performed by him/herself or another co-worker if the working conditions or behaviors are considered unsafe.All employees shou_Id act proactively to ide tify and mitigate hazards to the safest extent of their ability- Collect bilit . Collect samples in Steel toed and shank shoes, Cross-contamination. Back Use proper lifting and bending techniques. Use knee pads or a accordance with sampling long sleeve shirt, hardhat, strain, inhalation or dermal kneeling pad-STANTEC/Contractor. plan. safety glasses with side exposure to chemical . Determine the best location to set the sample containers (avoid shields, hearing protection, hazards, slip and fall. stepping on them, or other materials coming into contact with them)- reflective safety vest, and Improper labeling or STANTEC. leather gloves for the non- storage, injury from broken * Label samples in accordance with sampling plan-STANTEC. chemical aspects of work as sample bottle (cuts or acid Az necessary. If you suspect that burn). Note: If a sample • Fill sample containers slowly and over a bucket to eliminate equipment is contaminated, bottle breaks while potential spills. Or place sample container on bucket lid on the wear chemical resistant gloves. sampling, follow the ground or other surface, then fill container. To avoid sample Wear appropriate air-purifying guidelines listed below for container from slipping out of your nitrile gloved hand-'STANTEC. respirator with combination proper containment and organic vapor/P-1 00 cartridges disposal of broken glass. • Do not over pack cooler-STANTEC. as needed.Wear appropriate • Use bubble wrap or other insulating material for cushioning sample chemical resistant suit as. needed. Level D'PPE with containers in.the cooler-.STANTEC. . nitrile gloves, Traffic Vest, • Keep samples stored improper containers, at correct temperature, Exclusion Zone Equipment, and away from work area. Handle bottles carefully- Leather Work Gloves. STANTEC/Contractor. • Perform personal decontamination procedures STANTEC/Contractor. . . z. * • Drop off tools and perform equipment decontamination procedures on the equipment:STANTEC/Contractor. • Remove inner/outer gloves and dispose of properly- STANTECIContractor. w STANTEC Consulting Corporation 13-16 ' ��_