WORK PLANS - Laserfiche WebLink

Home Browse Search

Field staff must review job-specific work plan and coordinate with project manager to verify that all up-front logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts (e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety meeting must be performed and documented at the beginning of each workday. Plan, Prevent, Execute (PPE)/Safe Performance Self Assessment(SPSA) procedures must be used throughout the project. Weather conditions(heat, cold, rain, lightning) must also be considered. Each employee is empowered, expected, and has the responsibility to stop the work performed by him/herself or another co-worker it the working conditions or behaviors are considered unsafe.All employees should act roactivel to identifV and mitigate hazards to the safest extent of their abili . RNMEN,MEMO 1 01111, i Set up exclusion zone(s) Wear reflective vest for traffic, Struck by vehicle during • Implement exclusion zone set-up. and workstations(drilling steel toed and shank shoes, set up. Slip, trip and fall Stantec/Contractor. and logging/sample hardhat, safety glasses with hazards. • It is the responsibility of the SHSO to annotate the Site Plan with collection). side shields, and leather gloves the Exclusion Zone set up. Stantec. as necessary. • Set up workstations with clear walking paths to and from rig. Stantec/Contractor. • Use safety tape, snow fence, and/or delineators. Stantec/Contractor. • If utilizing Visqueen, (sheet plastic), for sampling area, completely secure Visqueen to the pavement, dirt, etc with duct tape, delineators, etc Do not use objects that are hard to notice or could become a trip hazard themselves. Stantec/Contractor. Clear total depth of Don required PPE as Back strain, exposure to • Inform drillers that they may use a mallet to strike the auger bucket borehole (approximately appropriate for this step: steel chemical hazards, hitting to loosen/remove soil. However, one hand should be placed on the 5.5 feet) using a hand toed and shank shoes, hard an underground utility, connection point between the hand auger bucket and the auger rod auger hat, safety glasses with side repetitive motion. and the other hand should be holding the mallet. The hand auger shields, hearing protection, should be secured and stable before using a mallet to remove soil. reflective safety vest, and from the auger bucket Stantec/Contractor. leather gloves for the non- • Proceed cautiously and periodically stop to observe conditions in chemical aspects of work as the open hole. Use a high-beam flashlight or mirror to reflect sunlight necessary.Wear chemical ._ into_the_hole for.observations.. _-._-. _ reds an g oves unng h6il Trig Stantec/Contractor. of soil.Wear an air-purifying • Care should be exercised in identifying resistance to excavation or _. respirator with combination__ recalcitrant-objects-as-they-may-not-appear-identifiable-until`more- organic vap&/P-100 cartridges fully exposed (i.e. you might break a pipe in the process of clearing if necessary. the hole before you are aware it is a pipe. Go Slowly-Visually Check Frequently). Stantec/Contractor. • Use proper lifting techniques and tools. Stantec/Contractor. - • Complete the Pre-Drilling section of the Borehole Clearance Review form. Stantec. •Avoid twisting back during the operation; Decontaminate equipment after use. Decontamination will be accomplished by a Liquinox wash with tap water rinse followed by a de-ionized or distilled water rinse. Collect rinse water in 5 gallon buckets and transfer to 55-gallon drums and stage drums Stantec/Contractor. STANTEC Consulting Corporation 13-29